User manual CLATRONIC HSMR 2687 OTHER MANUAL

[. . . ] Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. the appliance is designed exclusively for private use and for the envisaged purpose. Do not use it outdoors (except if it is designed to be used outdoors). [. . . ] For DIRECT CONNECTION MODE insert the plug of the adapter into a 230V/50Hz socket, insert the connection cable into the connection socket located on the hair clipper and place the function selector to ON. After this time it must be switched off and allowed to cool down for 10 minutes. Useful tips regarding battery life Battery life can be lengthened by paying attention to the following instructions: · Wait until the battery is almost completely flat before recharging. ⷠNever leave the machine connected to the charger for more than 24 hours. ⷠCharge the machine only with room temperature between 0 and +40°C. Start with the longest cutting level and trim your beard gradually to the desired length. Note: Lock the selected cutting length (cutting length comb) in position with the locking switch located on the back of the housing (position 8 ­ , , lock"). Start with the longest cutting level and shorten the hair gradually to the desired length. Note: Lock the selected cutting length (cutting length comb) in position with the locking switch located on the back of the housing (position 8 ­ , , lock"). The shearing head enables the precise trimming of the beard contours even areas, which are difficult to reach, and a clean shaving of the hairline in the neck area. ⷠAfter use remove each time all hair left on the machine with the supplied brush. ⷠRemove the cutting comb and the cutting head to either blow off the hair particles or brush them off with the cleaning brush. After using the machine apply each time 1-2 drops of an acid-free oil (sewing machine oil) on the cutting head. This appliance conforms with the CE directives for radio interference suppression and low-voltage safety and has been built to meet current safety requirements. [. . . ] Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. ) as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid!After the expiry of the guarantee repairs can be carried by the competent dealer or repair service against the payment of the ensuing costs. [. . . ]