User manual CLATRONIC HMS 2739 OTHER MANUAL

[. . . ] Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. If you should leave the workplace, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead). [. . . ] Press the end of the kneader hooks/beater (10) into the corresponding mixer openings until the hooks click into place. While pressing, turn slightly in order to facilitate the whole operation. Please note that the kneading hook with the curved washer on the shaft can only be inserted on the left-hand side of the mixer when viewed from the bottom. Insert the mains plug into a properly installed 230V/50 Hz safety power socket. The handmixer (1) can be used at various speeds set with the speed regulator (3). In order to release the kneading hook/whisk (10) turn the power level selector switch to "0/AUS" and ensure that the mixer has been disconnected from the mains. How to use the Mixer stand Please check whether the clip (12) of the upper section is locked in place on the back of the mixer. Mount the hooks as described above in the section "How to use the Kneader hooks/beater". In order to place the mixing bowl (8) underneath, pull the clip (6) to unlock the upper section of the mixer stand (5) and fold the mixer upwards. Place the mixer bowl filled with the desired ingredients onto the revolving plate (7). Insert the mains plug into a properly installed 230V/50 Hz safety power socket. The handmixer (1) can be used at various speeds set with the speed regulator (3). When you would like to stop mixing, turn the power level selector switch to "0" and unplug the device from the mains. When you have finished pull the clip (6) again to unlock the upper section of the mixer stand (5) and fold the mixer upwards. Remove the hooks as described above in the section "How to use the Kneader hooks/beater". In order to separate the mixer from the upper section (5) of the mixer stand, pull the mixer upwards. [. . . ] *) Damage to accessories does not mean automatic free replacement of the whole machine. Broken glass or breakage of plastic parts are always subject to a charge. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]