User manual CLATRONIC ES 2657 2

[. . . ] Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. [. . . ] To remove the used coffee, hold the filter by using the special lever (11) on the handle in the relevant position. By doing so, you will extend the service life of the rubber seal in the brewing head. To make other espressos, fill the coffee bowl (12 or 13) with coffee powder again and carry out the brewing procedure as described above. Swing the steam nozzle (8) out so that you can position the container (please use a heat-resistant container) comfortably under the nozzle. Fill the container up to a 1/3 with fresh cold milk (warm, hot or stale milk does not froth). Dip the steam nozzle (8) slightly below the surface of the milk in the container and turn the function selector (3) to the left (Steam symbol). Once the milk reaches the desired volume, you can warm the milk more by lowering the steam nozzle (8) to the bottom of the container. Turn the function selector (3) back to the O position and switch the device off with the On/Off (O/I) (6) switch. A cappuccino is usually composed of 1/3 coffee, 1/3 hot milk and 1/3 frothed milk. You can even use the Espresso machine to make tea, hot drinks and meat soups. Both LED's (4 ­ 5) to the left and right of the function selector light up. When the READY LED (5) is off, the water has reached the right temperature and the function selector (3) can be turned to the left to Steam position. [. . . ] In this case, only the faulty accessory will be sent in or ordered with the agreement of our customer service!Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]