User manual CLATRONIC ES 2612 2

[. . . ] In order to ensure that there is no residual steam pressure from the previous time coffee was made, leave the machine to cool down for a few minutes and then turn the filter holder (7) slowly in the direction of , , OPEN". Ensure that during operation the filter holder (7) is correctly closed and secured, as the machine works under pressure. Before the first use Before brewing your first espresso or when the equipment has not been used for a certain time, please remove all air out the system by pumping fresh Water through the system. [. . . ] This way you are able to place the jug (please use a heat resistant jug) comfortably under the valve. Hint: Place an empty jug under the valve, close the steam control switch and for partly opening the steam valve please turn counter clockwise so all condensation build within the steam valve can escape. Fill the jug one third with fresh cold milk (warm, hot or old milk will not froth). Immerse the steam valve just below the surface of the milk and open the steam valve. Once the milk has reached the desired volume you can heat it up even more by immersing the steam valve almost to the bottom of the jug. Cappuccino usually consists of one third coffee, one third hot milk and one third frothed milk. Put a heat resistant jug filled with water under the valve and open the steam valve. If you would like to proceed making espresso after producing steam, put an empty jug under the brew head. press the pump button , to refill the water supply for the heating system. When water runs out the brew head and the steam- and the readiness lamp switch of release the pump button. Proceed as described under 1 ­7 , , making Cappuccino" but instead of milk please pour the liquid to be heated in the jug. In case the steam control lamp switches off or no steam is being produced, the water tank is possibly empty. Press the pump button and as soon as water runs out the brew head release the pump button. Please Note: Whilst using the steam function water can spill out the steam valve, this is entirely normal. As soon as the water flows through the brew head release the pump button and wait until the readiness lamp lights up. As soon as the required amount of hot water is reached, release the pump button and close the steam valve entirely. [. . . ] Check whether the steam button is pressed Steam valve was not opened No water in the water tank / boiler Steam valve is blocked. This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations. The device supplied by our Company is covered by a 24 month guarantee starting on the date of purchase (receipt). [. . . ]