User manual CLATRONIC ES 2573 2

[. . . ] To avoid the exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer service or by a qualified person and with a cable of the same type. Pay careful attention to the following "Special Safety Instructions". To clean the device, carry out 2-3 complete cycles with clean water before brewing the first espresso. [. . . ] Release the filter holder (10) by turning the handle to the left (INSERT). Distribute the coffee evenly and press the coffee powder lightly with a measuring spoon or other spoon. The aim of pressing the coffee powder with the spoon is to distribute it evenly in the coffee bowl rather than compressing it. In order to preheat your espresso cups, place them on the warming plate (2) above the percolating head. The control lamps (4+ 5) located on the right and left in the function control light up. Note: if the control lamp lights up again before percolation is finished, the water temperature is no longer high enough. Turn the function selection switch (3) to O and wait for the lamp to go out again. Remove the espresso cup(s) from the warming plate (2) and place them under the percolating head. After frothing milk, the steam nozzle is to be immediately cleaned from all milk residues. Soak the steam tube in a container with water over night so that the milk residue softens. Wipe the steam nozzle with a moist cloth to remove the milk residue before it hardens. The water tank, drip tray, drip tray cover, filter, filter holder and the hotplate can be washed by hand in a sink with warm water. To empty the tray you can remove the drip tray completely and lift the grid. This appliance conforms with the CE directives for radio interference suppression and low-voltage safety and has been built to meet current safety requirements. The device supplied by our Company is covered by a 24 month warranty starting on the date of purchase (receipt). During the life of the warranty any fault of the device or its accessories *) ascribable to material or manufacturing defects will be eliminated free of charge by repairing or, at our discretion, by replacing it. [. . . ] The warranty services do not entail an extension of the life of the warranty nor do they give rise to any right to a new warranty!Without proof of purchase no free replacement or repair will be carried out. For repairs or replacement during the life of the warranty return the device in its original packing together with the proof of purchase to your dealer. [. . . ]