User manual CLATRONIC DR 2890 NEW

[. . . ] Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. If you should leave the workplace, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead). To protect children from the dangers posed by electrical appliances, make sure that the cable is hanging low and that children do not have access to the appliance. [. . . ] Open the cover on the main device and attach the connection head (17). Please open the safety lock (4) only when no more steam comes out of the nozzle. If the device is still warm, please wait 5 minutes before removing the seal completely. If the pressure in the kettle is still too high, this release device prevents it from being opened. In order to release the nozzle again, please press the button on the steam pistol. Keep the button pressed down and then pull the nozzle off Or extend the nozzle attachments with one or two extension tubes (10). Please insert the two-parts of the extension tube into one another until they lock into place and then attach them to the steam pistol (3). In order to release the extension tube, please press the button on the steam pistol. Note: The round brush attachment can only been used in conjunction with the jet nozzle. Jet nozzle with round brush attachment (11): Floor brush nozzle (12): Window wiper (13): Non-woven cover (14): For cleaning joints, the edges of bath tubs or areas which are difficult to access etc. Before inserting the mains lead into the socket, check whether the voltage you intend to use complies with that of the machine. After you have filled the kettle with water and selected a cleaning attachment, please proceed as follows: 1. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. If you have not done so already, open the cover on the main device and attach the connection head (17). If there is no more water in the vessel no steam is emitted when the steam switch (5) is pressed. Wait for approximately 5 minutes and release the residual pressure with the steam switch!Slowly open the safety lock (4) and wait a few seconds before opening it completely until the overpressure has been released. If the pressure in the kettle is still too high, this release device prevents it from being opened. In order to prevent water from splashing, the water should be filled in slowly after the safety lock has been opened. Reinsert the plug into the socket and switch on the device using the on/off switch. [. . . ] If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt. *) Damage to accessories does not mean automatic free replacement of the whole machine. Broken glass or breakage of plastic parts are always subject to a charge. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]