User manual CLATRONIC DR 2812 NEW

[. . . ] Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. If you should leave the workplace, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead). [. . . ] 1 2 3 4 5 6 7 On/off switch Kettle/water tank Hose with connecting head Safety lock/Filling aperture Steam switch on the connecting head Carrying handle Connection cable 8 9 10 11 Funnel Measuring beaker 2 extension tubes Jet nozzle with round brush attachment 12 Floor brush nozzle 13 Window wiper 14 Non-woven cover Before the tank lock is opened the power plug must be removed from the socket. Before unscrewing the lock (4) proceed as follows: Remove the power plug from the socket. If the device is still warm, please wait 5 minutes before removing the seal completely. Please open the safety lock (4) only when no more steam comes out of the nozzle. Then fill the measuring beaker (9) and pour the water into the kettle. Attach one of the nozzles to the connecting head of the hose until it locks in place. In order to release the nozzle again please press the button on the connecting head of the hose. Keep the button pressed down and then pull the nozzle off Or extend the nozzle attachments with one or two extension tubes (10). Insert one extension tube into the other until it locks in place and then insert the connected tubes into the handle section (3). In order to release the extension tube, please press the button on the connecting head. Jet nozzle with round brush attachment (11): Floor brush nozzle (12): Window wiper (13): Non-woven cover (14): For cleaning joints, the edges of bath tubs or areas which are difficult to access etc. Before inserting the mains lead into the socket, check whether the voltage you intend to use complies with that of the machine. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. If there is no more water in the vessel no steam is emitted when the steam switch (5) is pressed. Please turn the device off by moving the on/off switch (1) to "0". Wait for approximately 5 minutes and release the residual pressure with the steam switch!Open the safety lock (4) slowly while pressing down at the same time and wait a few seconds before opening completely after the overpressure has been relieved. Fill fresh water from the measuring beaker (9) by means of the funnel (8) into the boiler. [. . . ] *) Damage to accessories does not mean automatic free replacement of the whole machine. Broken glass or breakage of plastic parts are always subject to a charge. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]