User manual CLATRONIC DR 2811 NEW

[. . . ] Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. If you should leave the workplace, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead). [. . . ] If the device is still warm, please wait 5 minutes before removing the seal completely. Please open the safety lock (3) only when no more steam comes out of the nozzle. Then fill the measuring beaker (8) and pour the water into the kettle. The mark on the nozzle and the I mark on the device should be aligned with one another. Turn in the direction of the arrow (in a clockwise direction) until the mark on the accessory is aligned with the II mark on the device. The nozzle attachment can be used on the hose or directly on the device. The nozzle attachment and the universal cleaning attachment (13) can be fixed to the end of the hose. The universal cleaning attachment should be used either together with the non-woven fabric attachment (9) or with the window cleaning attachment (14). Before inserting the mains lead into the socket, check whether the voltage you intend to use complies with that of the machine. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. If there is no more water in the vessel no steam is emitted when the steam switch (4) is pressed. Wait for approximately 5 minutes and release the residual pressure with the steam switch!Unscrew the safety lock (3) slowly and wait for a few seconds before opening it completely until the excess pressure has escaped. Fill fresh water from the measuring beaker (8) by means of the funnel into the boiler. In order to prevent the water from splashing it should be filled into the funnel slowly after the safety lock has been opened. Cleaning and maintenance must only be carried out when the power plug is removed from the socket. [. . . ] *) Damage to accessories does not mean automatic free replacement of the whole machine. Broken glass or breakage of plastic parts are always subject to a charge. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]