User manual CLATRONIC DR 2765 NEW

[. . . ] Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull on the plug, not the cable) if the appliance is not being used and remove the attached accessories. If you should leave the workplace, always switch the machine off or remove the plug from the socket (pull the plug itself, not the lead). [. . . ] Please open the safety lock (3) only when no more steam comes out of the nozzle. Fill water from a measuring beaker (8) through the funnel (7) into the boiler. Round brush, curved nozzle The round brush and the curved nozzle can be attached to the jet nozzle at the hexagonal joint. The mark on the nozzle and the yellow mark on the device must be aligned with one another. Turn in the direction of the arrow (clockwise) until the mark on the attachment is aligned with the line on the device. Then the jet nozzle (11) and the fabric brush (13) can be attached to the end of the hose. Before inserting the mains lead into the socket, check whether the voltage you intend to use complies with that of the machine. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. If there is no more water in the vessel no steam is emitted when the steam switch (4) is pressed. Wait for about 10 seconds and then release the residual pressure by means of the steam switch. Unscrew the safety lock (3) slowly and wait for a few seconds before opening it completely until the excess pressure has escaped. Fill fresh water from the measuring beaker (8) by means of the funnel (7) into the boiler. In order to prevent the water from splashing it should be filled into the funnel slowly after the safety lock has been opened. Cleaning and maintenance must only be carried out when the power plug is removed from the socket. Before putting the device away or cleaning it, it has to be allowed to cool down completely. Please clean the device and the accessories only with a slightly moist cloth. [. . . ] *) Damage to accessories does not mean automatic free replacement of the whole machine. Broken glass or breakage of plastic parts are always subject to a charge. Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. [. . . ]