User manual CLATRONIC DBS 2521 NEW

[. . . ] Before commissioning this device please read the instruction manual carefully. â· Please keep these instructions, the guaranty certificate, the sales receipt and, if possible, the carton with the inner packaging! â· The device is intended exclusively for private and not for commercial use! [. . . ] â· Should the device become moist or wet, remove the mains plug from the socket immediately. The ironing base becomes hot very quickly and takes a long time to cool down. Do not fill more than one litre of cold water into the water tank Do not bend the steam hose. Temperature control Steam control Pump button with lock Spray button Spray nozzle Steam-jet button Control lamp 8 9 10 11 12 13 14 Removable water tank Filling inlet and anti-limestone cartridge Iron well Mains lead Connecting tube Power indicator light Unlocking button Clean the ironing base with a slightly damp cloth. In order to remove all residues before initial use, please pass the iron a few times over an old clean cloth. Fill the water tank by the filling aperture (9) with not more than one litre of pure water. NOTE: If no steam comes out when the first time the machine is used and all instructions have been followed, keep the pump button pressed (3) for approx. One minute so that the water is pumped from the water tank into the iron. Ironing without Steam The clothes to be ironed should be sorted out according to their ironing temperature. Insert the plug into a correctly installed safety power socket, 230 V, 50 Hz. As soon as the control lamp goes off the operating temperature has been reached. With the button (6) it is possible to produce a short, powerful jet of steam. The lifetime of the anti-limestone cartridge (9) depends on the frequency of use and the hardness of the water. it is recommended that if the water hardness is 2 and the average ironing time approx. [. . . ] In this case only the faulty accessory needs to be ordered without sending back the whole appliance!The cleaning, servicing and replacement of wear parts are not covered by this warranty and hence are to be paid for. Once the warranty has expired, repairs can be carried out by specialized technicians or repair services against the payment of the service. [. . . ]