User manual CLATRONIC DB 2897 NEW

[. . . ] Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. the appliance is designed exclusively for private use and for the envisaged purpose. Do not use it outdoors (except if it is designed to be used outdoors). [. . . ] Fill the water reservoir at the refill opening (8), using a filling container. Preferably use distilled water or clear tap water (maximum water hardness level 2). Do not fill battery water, water from the clothes dryer and water containing additives (such as starch, perfume, softener or other chemicals) into the water reservoir. this could damage the iron due to residues forming in the steam chamber. These residues may cause impurities to the fabric when dropping out of the holes in the soleplate. Remove any protective films and adhesive labels from the stainless steel soleplate before using the appliance. Electrical connection Make sure that the iron voltage (see name plate) and the line voltage match. Always move the temperature control to the lowest temperature setting (before , , b - Synth") prior to connecting the appliance with, or disconnecting it from a power point. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. The quantity of steam can be regulated using the steam quantity regulator (4). When ironing at low temperatures, make sure that you reduce the quantity of steam or iron without steam. Vertical Steam This can be used to produce a jet of steam in a vertical direction. Note: To avoid excess water leaking from the soleplate do not operate the steam burst for more than 5 seconds without interruption. After the control lamp goes off remove the machine from the mains supply. After use, always set the steam control to the lowest level and empty the water reservoir to prevent the contents of the tank from leaking. This device has been tested according to all relevant current CE guidelines, such as electromagnetic compatibility and low voltage directives, and has been constructed in accordance with the latest safety regulations. [. . . ] Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. ) as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid!After the expiry of the guarantee repairs can be carried by the competent dealer or repair service against the payment of the ensuing costs. [. . . ]