User manual CLATRONIC CTV 629 VT PROGRAMMING

[. . . ] ) as well cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid!Do not place anything on the television and ensure a minimum distance 5cm around the apparatus for sufficient ventilation. If your television mains lead or plug becomes damaged or requires replacement, switch off your television, remove the plug from the socket and call a qualified service engineer. This television is meant to be used in the home in moderate climates (not in tropical climates) . [. . . ] After switching television set from standby to operating status, the red indicator go down. Your television set is controlled by using MENU tables Picture, Install, Setup. These tables appear on the screen after pressing remote control button MENU one or more times. The television set parameters and their values are arranged in these MENU tables. The line of table with required parameter you can select by using the remote control keys P+ or P-, and to change this parameter by using keys VOL+ or VOL-. MENU tables from the TV screen disappears after pressing the remote control key MENU one or several times or about after 5 seconds after the last action in these tables. Page numbers in coloured rectangulars will appear at bottom of the screen. You can select these pages by pressing corresponding coloured buttons. If TV station does not broadcast Teletext information, so after switching Teletext on, a black line with page number appear in the top of the screen. The required outer signal source you can select by pressing the AV key on the remote control (depending to the model). The required picture parameter you can select by using remote control keys P+, P-, and to change value of this parameter by using keys VOL+, VOL-. Quick start guide Tuning your television set You can tune your television set in two ways: automatically or manually. Your TV will now automatically tune and store all your local TV stations. On completion of automatic tuning the first programme is automatically shown on the screen and you can select the desired programme by using the remote control buttons P+, P-, 0, 1, . For labelling, moving or hiding of tuned programmes you can use the menu Organize. For better picture quality your VCR or satellite receiver should be connected to SCART socket on your TV set. If you do not use the SCART socket, for receiving VCR signal via aerial socket a programme with number 99 is recommended. Install two batteries into the remote control according to the diagram inside the battery compartment. Plug your TV power lead into the mains socket and press button on the front panel. , 9 key on the remote control, or use P+, P- keys on the front panel to switch the TV set from standby to ON. You can move programmes to the desired positions by using menu Organize now (see "Customizing your stored programmes"). If notes that are not described in this instruction appears on TV screen (because of external disturbances), press the PP on the remote control. [. . . ] When lock is activated, and you want switch on TV, you must enter the code by using the 0, 1, . If you want cancel the code, you must select the Setup Function menu, then highlight Lock, and using the VOL+ or VOL- keys cancel the lock (No). Note: If you will forget lock code or dial it wrongly, press remote control key PP 3 times. If you make a mistake or do not need automatic switching anymore, you can cancel it by selecting Time in Setup menu and pressing OK on the remote control. [. . . ]