User manual CLATRONIC CL 3134

[. . . ] This device was designed to air condition living space and must not be used for other purposes. You should not use this air-conditioner in the immediate vicinity of a bath, shower or swimming pool. If the air-conditioner should fall over, remove the plug from the socket and allow the device to cool down before righting it. Empty the condensation container inside the device before moving it or storing it away. [. . . ] For your own safety the battery poles should be covered with adhesive strips during transport. NOTE: Some buttons are to be found both on the device and on the remote control. Do not through the packaging away, but keep it together with the inner packing and the warranty documents for the whole life of the warranty. Do not insert the appliance plug without installing the necessary attachments. NOTE: Changing the Mode of Operation When the mode of operation is changed the compressor remains switched off for approximately 6 minutes until the pressure in the refrigeration circuit has eased. cooling · If you would like to change the room temperature using the , , cooling" mode of operation, press the , , " or , , " button (D/F). By repeatedly pressing the , , " button (16) on the remote control you can switch from 18, 19, 20. The device cools the room down to the set temperature, which it then maintains. If the set temperature is above the current room temperature, the device switches the cooling off and only the ventilator continues running. NOTE: The rate at which the desired temperature is reached depends on the temperature of the room and the outside temperature. Ventilator Speed In the , , cooling" and , , ventilator" modes it is possible to set 3 different levels for the speed of the ventilator. The speed changes " button (G/15): with each press of the , , Red ­ for a high speed Green ­ for a medium speed Orange ­ for a slow speed Turn the connection ring at least five times in a clockwise direction until it is tight. Push the assembled exhaust air hose from right to left over the hose connection (9) on the back. In order to release the hose again, press in the right-hand retainer and push the hose to the right out of the holder. Under no circumstances should you pull the lead any further with force, as this may damage the device. Only connect the machine to a properly installed safety socket, 230 V/50 Hz. Make sure that the degree of protection of the socket to which the device is connected is of at least 10 ampere!The distance from the air inlet grille (5/7) to the nearest wall should be at least 20 cm. [. . . ] In order to empty the water container, please proceed as follows: · Turn the device off (, , " control lamp lights up in red) and remove the plug from the socket. The air filters should be cleaned regularly by rinsing out under running water. The device is too loud Control lamp , , " (K) lights up The noise emission value in the workplace is less than 70 dB(A). Reinstall the filters, ensuring that they are inserted correctly into the slide mounting. [. . . ]