User manual CLATRONIC BS 1232 NEW

[. . . ] Read the operating instructions carefully before putting the appliance into operation and keep the instructions including the warranty, the receipt and, if possible, the box with the internal packing. the appliance is designed exclusively for private use and for the envisaged purpose. Do not use it outdoors (except if it is designed to be used outdoors). [. . . ] Please insert the sections of the 2-part suction tube (11) into one another and then attach them to the handle section. Insert the mains plug into a correctly installed safety socket (230 V, 50 Hz) and then switch the machine on using the on/off switch (2). Attention: pay attention to the range that can be covered with the cable length. Vacuum power regulator Low vacuum power: Medium vacuum power: High vacuum power: Cable winding device: Pull out the cable (1) up to the maximum length indicated with the yellow mark. Never pull the cable out up to the red mark as the cable winding can be damaged. Nozzle Attachment: The nozzle attachment is located below the take-up device for the mains lead or below the outlet filter. crevice nozzle/Brush nozzle: For vacuuming upholstery , curtains and in corners and crevices etc. "2-in-1" nozzle: When this is folded together (as stored in the compartment) it can be used as a groove nozzle. If you would like to use the brush nozzle, pull the brush section in the direction of the arrow until it locks in place. Smooth floors: Press down the lever with the brush symbol with your foot. If necessary, the filter can also be washed in warm water without any additives. It is located on the rear part of your appliance behind a ventilation grid. open the ventilation grille by pressing the buttons above it simultaneously. Fit the filter back into place and close the ventilation grid by following the steps above in the opposite order. [. . . ] Motor pistons, kneading blades, drive shafts, spare remote control, spare toothbrushes, saw blades, etc. ) as well as cleaning, maintenance or the replacement of said parts are not covered by the guarantee and hence are to be paid!After the expiry of the guarantee repairs can be carried by the competent dealer or repair service against the payment of the ensuing costs. [. . . ]