User manual CLATRONIC AR 663 CD NEW

[. . . ] The built-in safety switches should prevent the user being exposed to dangerous laser light, which is invisible to the human eye, when the CD compartment is opened. Under no circumstances should these safety switches be bypassed or manipulated, as this could result in a danger of exposure to the laser light. Please install the car radio as shown below Note: h Retaining screws during transport (please remove before installation) First place the operating panel in position on the right-hand side and then lock it into place on the left. Do not attach the removable control panel until after connection of the cables. [. . . ] reception of this station data is shown in the display by the EON symbol. You can choose between the EONTA LOCAL and EONTA DISTANCE mode for local or long-distance traffic news. The purpose of this function is to prevent the radio switching unnecessarily to an EON-TA traffic news item. If an EON station is a long distance away, it may be that in some cases EON TA information can still be received from the station. The radio then switches to this EON station and tries to receive the traffic announcements. The signal is too weak, however, and reception is poor as this EON station is too far away. Therefore the radio switches back to the station that was set previously. During the type of operation described above the listener hears the wrong programme for a short time or nothing at all. EONTA LOCAL: This function prevents switching to an EON station whose signal is too weak. The radio does not switch to this station and the listener does not hear any interference. EONTA DISTANCE Mode: In this mode the EONTA circuitry tries to receive the EONTA information from any available transmitter and thus improve reception quality. VOL LAST/VOL ADJ With the help of the +- and ­ buttons you can select one of the settings: VOL LAST: The radio switches on at the actual volume it had when it was last switched off. To switch on press this button briefly; to switch off keep it pressed down. BAND button Press the BAND button briefly to switch between the three FM levels. MUTE Button Press the MUTE button to switch off the loudspeakers for a short time. AP Button (Autostore - Automatic Station Storage) In radio mode: a) Memory function : Press the AP button for longer than one second to activate automatic station storage. FM 1, for the strongest signal level until the search cycle has finished. the six strongest stations are then allocated to the corresponding storage locations. The stations that have now been stored are played for approximately 5 seconds each and then the station of the first storage location is set. If you would like to search for more stations in the FM band, press the BAND button in order to change to the FM 2 or FM 3 band. Press the AP button again for more than one second in order to start the continued search. B) Scan Function: After the AP button has been pressed briefly the radio plays all the pre-set stations in the current frequency band for a short time. [. . . ] During the life of the guarantee any fault of the device or its accessories *) ascribable to material or manufacturing defects will be eliminated free of charge by repairing or, at our discretion, by replacing it. The guarantee services do not entail an extension of the life of the guarantee nor do they give rise to any right to a new guarantee!Without proof of purchase no free replacement or repair will be carried out. If you wish to make a claim under the guarantee please return the entire machine in the original packaging to your dealer together with the receipt. [. . . ]