User manual CASIO SF-4900ER

[. . . ] SF-4900ER SF-4980ER SF-4985ER User's Guide E CASIO ELECTRONICS CO. , LTD. Veuillez conserver votre manuel et toute information pour une rfrence future. Before using the unit for the first time Use the following procedure to load batteries and reset the unit before using it for the first time. Slide the battery compartment cover in the direction indicated by the arrow. RESET 2. Slide the battery switch to the "REPLACE 1" setting. REPLACE RESET NORMAL 3. [. . . ] In the Schedule Keeper, the appearance of the currently displayed date depends on whether or not Schedule Keeper data is already stored under that date. 41 PART 3 Data Management Functions No data stored Data already stored (Index Display) Schedule Keeper data entry In the case of the display on the right (data already stored), you can display the "TIME?'' prompt by pressing CLEAR. To input Schedule Keeper data 1. Press SCHEDULE to enter the Schedule Keeper, and enter a date as instructed in "To specify a date". Input the starting time of the appointment, pressing TIME/DATE between the hour and the minutes. If you are using the 12-hour timekeeping format, be sure to press A to specify AM or P to specify PM when inputting time. To create a Schedule Keeper data entry with a description only (without any start time or end time), press NEXT (to advance directly to step 7) without entering a time. To create a Schedule Keeper data entry with a start time and description only (without any end time), press NEXT (or J) (to advance directly to step 7) instead of TIME/DATE. Input the ending time of the appointment, pressing TIME/DATE between the hour and the minutes. If you want to set a schedule alarm, press NEXT (or L) after inputting the description. After inputting the data, press SET to store it into memory. 42 Using the Schedule Keeper Using Schedule Alarms You can set schedule alarms for Schedule Keeper data entries to help you keep on time for important appointments. Note the following important points when you are using a schedule alarm. The alarm indicator and time are automatically cleared after the alarm time is reached. Schedule alarms can only be set for Schedule Keeper data entries that include time data. If you set a schedule alarm for a Schedule Keeper entry with time data and then later clear the time data, the schedule alarm is also cleared automatically. To set a schedule alarm when inputting data 1. Enter the Schedule Keeper and input data, using the procedures described in steps 1 through 7 under "To input Schedule Keeper data'' on page 42. You can press the NEXT (or L) without inputting anything for the description. Use the J and H cursor keys to move between the hour and minutes setting. Time data Schedule alarm indicator Schedule alarm time You can skip this input if you want the schedule alarm time to be the same as that for the schedule data time. Whenever the schedule alarm setting is shown on the display, pressing DEL clears the alarm time and displays the prompt "ALM TIME?'' Input the alarm time using the same procedure described above. Note that the schedule alarm setting is cleared from the display when you press SET. If you attempt to set a schedule alarm time that is already passed, the message "ALARM TIME ALREADY PASSED!'' appears on the display. Then the data is stored without a schedule alarm. 43 PART 3 Data Management Functions If you attempt to set a schedule alarm time that is already set for another data entry, the message "ALARM TIME ALREADY USED!'' appears on the display. [. . . ] In the Conversion modes, pressing this key toggles between general conversion and euro conversion. CAPS CODE Code key Cursor Right key Cursor Left key Cursor Up key Cursor Down key Delete/Insert key J H K L DEL INS Display Change key DISP CHNG 106 Keys Key Cap ESC FUNC HOME/ WORLD A Name Escape key Function key Home/World Time key Letter keys Function Press this key to interrupt any operation. Use the CAPS and SHIFT key to switch between upper-case and lower-case letters. Press this key to complete input of a data entry and move to the next data entry. Press SHIFT and then hold down CAPA key when you want to display the current status of the memory. [. . . ]