User manual CASIO KL-C500

[. . . ] KL-C500 User's Guide Important Safety Precautions Note of the following safety precautions before using the label printer for the first time. Keep these safety precautions and operating instructions on hand for future reference. Serious malfunction Continued use of the unit when smoke or a strange odor is coming from it creates the danger of electrical shock. Immediately turn power off and unplug the power cord from the wall outlet. AC power cord Do not allow the power cord to become damaged or broken, and never modify, over bend, twist, or pull it. [. . . ] While there is text on the display, press STYLE. To change the font for lines of text 1. After performing the two steps under "To change the font for displayed text", use u and i to highlight "LINE" and then press SET. Move the cursor to the start line from which you want to change the font and then press SET to register your selection. Move the cursor to the end line up to which you want to change the font and then press SET to register your selection and change the font. At this point, the label printer returns to the text input screen. To change the font for specific characters 1. After performing the two steps under "To change the font for displayed text", use u and i to highlight "CHARACTER" and then press SET. Move the cursor to the start character from which you want to change the font and then press SET to register your selection. Move the cursor to the end character up to which you want to change the font and then press SET to register your selection and change the font. At this point, the label printer returns to the text input screen. 2. Use u and i to highlight the style you want to change to and then press SET. The range setting procedures are the same as those for font range settings. CHARACTER: See "To change the font for specific characters". Normal and Italic style settings can be applied to illustrations To find out current font settings Use the t and y cursor keys to move the cursor around the display. The font indicator shows the current font setting for the character where the cursor is located. Neighboring characters with different font settings, may overlap on the printed tape. You can correct for this by changing the PITCH setting on the BLOCK FORMAT menu (see page E-25), or by inputting a space between the overlapping characters. The following table shows how STYLE settings affect illustrations (ILLUST). STYLE SETTING Normal Italic Bold Outline Shadow Raised Italic+Bold Italic+Outline Italic+Shadow Italic+Raised EFFECT ON ILLUSTRATIONS Normal Italic Normal Normal Normal Normal Italic Italic Italic Italic E-18 To find out current character style settings Use the t and y cursor keys to move the cursor around the display. The character style indicator points to the current character style setting for the character where the cursor is located. The K indicator points to the character style that is assigned to the character where the cursor is currectly located. oe indicates combination of a character style with italic (italic-bold, italic-outline, italic-shadow, italic-raised). The following table shows the indicator that appears on the upper-right corner of the STYLE menu. Indicator Meaning Normal Bold Outline Shadow Raised Indicator Meaning Italic Italic-bold Italic-outline Italic-shadow Italic-raised LINE This range specifies application of a text effect for all the text in a specific line. CHARACTER This range specifies application of a text effect for a specific character. Changing STYLE to italic also makes the print length longer. TEXT This range is used to specify text across various lines, etc. A TEXT range specification must begin and end with in the same block. To assign text effects Text Effects You get a choice of three text effects: shading, underline, and box. The text effects are applied to text on the display, in addition to the printed text. 1. [. . . ] Memory is full. Action Use a tape cartridge that is 36 mm or wider. Page E-8 E-33 E-42 E-36 E-37 INPUT TEXT WILL BE CLEARED!SET/ESC E-33 E-38 Specify the correct text or scroll through text in memory to find what you want. Delete memory data you no longer need and then perform the barcode store operation again. To perform another operation without recalling text, simply perform the operation. MEMORY FULL! [. . . ]