User manual CASIO FR-2550

[. . . ] Microwave oven containers · Never affix labels to containers used for heating food in a microwave oven. The label material contains metal, which creates the risk of sparking and burn injury when heated in a microwave oven. Heating in a microwave oven can also cause deformation of the container to which the label is affixed. English About safety precaution symbols The following symbols are used in this manual and on the product itself to alert you and others to the risk of personal and material injury. Warning This symbol indicates an item that can result in death or serious personal injury if ignored. [. . . ] After you load the tape cartridge, be sure to use the procedure described under "Tape Width Specification" on page E-7 to tell the Label Printer what is the width of the tape you are using. · Make sure that the tape does not extend too far past the tape guide. If it does, cut off the end with a pair of scissors. NO! E-6 4. Use a pencil or some other thin object to take up slack in the ink ribbon as shown in the illustration. · If the ink ribbon is slack when you load it into the Label Printer, it can break or cause some other problem. · Be sure to turn the ink ribbon take up spool only in the direction indicated by the arrow (a). · Turn the spool until the other spool (b) starts turning in the direction noted by the arrow. Slide the printer head release in the direction indicated by the arrow. · If there is a cartridge already in the Label Printer, remove it by grasping the cartridge on both sides with your thumb and forefinger, and lift straight up. Load the tape cartridge into the Label Printer, making sure that the tape and ink ribbon pass between the head and roller. To specify 6mm tape width 1. Press H and J to change the setting shown on the display between ON (6mm tape) and OFF (other tape width). When the caps mode indicator is not shown on the display, all letters are input as lower-case. Note that the Label Printer stays in the caps mode until you press the CAPS key again. If both the caps mode indicator and the shift indicator are shown on the display, the keyboard is shifted to lower-case input. · Effect indicators These indicators point to the character effect that is currently in use. · Mirror image printing indicator This indicator appears when the Label Printer is set up for mirror image printing. Normal (non mirror image) printing is performed when this indicator is not shown. · 6mm tape indicator This indicator appears when you use the procedure on page E-7 to specify you are using 6mm tape. Any character you input appears at the point where the cursor is located. · Character position marks These marks show where characters will appear as you input them. This part of the display is always blank when you turn power on. Basic Alpha-Numeric Input The following operation shows you the basic procedures for inputting letters and numbers. We will explain the procedure by inputting the following characters using the default initial power-on screen. Note · If you hold down any key, it will repeat its operation or input at high speed until you release it. To input alpha-numeric characters 1. [. . . ] · The following table shows the initial settings. Roller 5. Replace the tape cartridge and close the back cover. Item Display Memory SYMBOL SIZE EFFECT MIRROR MEMO DENSITY 6mm Reset Cleared Cleared AUTO (2×2) CANCEL OFF STR?3 OFF E-14 Troubleshooting · Power Supply Nothing appears on the display. Possible Cause Low batteries Batteries loaded incorrectly Replace batteries. [. . . ]