User manual CASIO CW-K85

[. . . ] E CW-K85 User's Guide · We recommend that you print on a disc* before you record anything on it. Printing on a disc that already has data recorded on it can cause the data to become corrupted. shall not be held liable for any loss or corruption of data on discs arising through the use of this printer. Be sure to read the Safety Precautions contained in this manual before trying to use the printer for the first time, and always keep this manual on hand for future reference. RCA502991-001V01 GUIDELINES LAID DOWN BY FCC RULES FOR USE OF THE UNIT IN THE U. S. A. [. . . ] With the area of the disc you want to print on facing downwards, slide the disc from right to left into the slit along the top of the printer. · Never insert anything besides discs into the slit. · If the disc has a logo or any other markings on it, be sure to position it so printing will be performed in an area that is blank. 21 E Important!· Check to make sure that there is no dirt, dust, or other foreign matter on the disc. Dirt or dust can scratch the recording surface of the disc and make it impossible to record data onto it. · Sliding the disc onto the slit with the recording side facing you will result in printing on the recording side of the disc, which will make the disc unrecordable. 6. · Never turn off the printer while it is performing a print operation. · Make sure there is nothing to the right of the printer that can obstruct movement of the disc when it exits the slit. · Never open the cassette cover while printing is in progress or while a disc is inserted in the printer. · If you have a problem removing a disc due to printer malfunction, try using the procedure on page 8 to remove it. 4. Slide the disc to the left as far as it will go. · Make sure you slide the disc to the left as far as it will go. Normal printing may not be possible if the disc is not positioned properly inside the printer. 7. When printing is complete, the disc will stop moving and the screen shown here will appear on the display. 5. · Never use the positioning guide for any other purpose besides aligning discs. After positioning the disc, be sure to remove the positioning guide before you start printing. 8. Pull the disc to the right and remove it from the printer. Positioning guide Printing will appear here. · Adjust the position of the disc so its logo or marking is parallel with the positioning guide and slit. · Note that the printer cannot print in an area of the disc that already has a logo or other markings. · You can skip this step if the disc you are using does not have a logo or other markings on it. E Important!· If you have trouble removing the disc from the printer, see page 8. 22 To create a disc label for the upper and lower print areas 1. In step 3 of the procedure under "To create a label for the upper print area of a disc" on page 19, select the icon that shows both AREA A and AREA B, and then input text into both areas. 2. After inputting the text for the label, press SET. · Now you can preview your disc label ("To check the appearance of a disc label layout", page 21) or print it without previewing (see below). Important!· Never turn off the printer while it is performing a print operation. · Never open the cassette cover while a print operation is in progress. [. . . ] Start up the computer. ENTIRE PHRASE COULD NOT BE RECALLED! 37 LOW BATTERY!· Temperature is below 10°C (50°F) Move the printer to a location where the temperature is within the operating temperature range (10°C to 35°C (50°F to 95°F)). · There is not enough memory available to save the data you are trying to save. Delete memory data you no longer need and try again. 10 MEMORY FULL! [. . . ]