User manual CASIO CTK-571

[. . . ] USER'S GUIDE GUÍA DEL USUARIO P CTK571/573-ES-1 Page 1 01. 8. 1, 2:47 PM GUIDELINES LAID DOWN BY FCC RULES FOR USE OF THE UNIT IN THE U. S. A. (not applicable to other areas). NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Before starting, you should first select the rhythm you want to use, and set the tempo. NOTE To switch back to the standard rhythm pattern, press the NORMAL/FILLIN button. To insert an intro Press the INTRO button to start the selected rhythm with an intro pattern. · With the above setup, the intro pattern is played and the auto accompaniment with intro pattern starts as soon as you play chords on the accompaniment keyboard. Using a Fill-in Pattern with a Variation Rhythm You can also insert a fill-in pattern while a variation rhythm pattern is playing. To insert a fill-in into a rhythm variation While a variation rhythm pattern is playing, press the VARIATION/FILL-IN button to insert a fill-in pattern for the variation rhythm you are using. NOTES · The standard rhythm pattern starts to play after the intro pattern is complete. · Pressing the VARIATION/FILL-IN button while an intro pattern is playing causes the variation pattern to sound after the intro pattern is complete. · Pressing the SYNCHRO/ENDING button while an intro pattern is playing causes the ending pattern to sound after the intro pattern is complete. Synchro Starting Accompaniment with Rhythm Play You can set up the keyboard to start rhythm play at the same time you play the accompaniment on the keyboard. Before starting, you should first select the rhythm you want to use, set the tempo, and use the MODE switch to select the chord play method you want to use (NORMAL, CASIO CHORD, FINGERED, FULL RANGE CHORD). 702A-E-021A E-19 ONE TOUCH PRESET MODE SYNCHRO/ENDING ACCOMP VOLUME [+]/[­] Number buttons To use synchro start 1. Adjusting the Accompaniment Volume You can adjust the volume of the accompaniment parts as a value in the range of 000 (minimum) to 127. Press the SYNCHRO/ENDING button to put the keyboard into synchro start standby. Flash 1. Press the ACCOMP VOLUME button. Current accompaniment volume setting 2. Play a chord and the rhythm pattern starts to play automatically. 2. NOTES · If the MODE switch is set to NORMAL, only the rhythm plays (without a chord) when you play on the accompaniment keyboard. · If you press the INTRO button before playing anything on the keyboard, the rhythm starts automatically with an intro pattern when you play something on the accompaniment keyboard. · Pressing the VARIATION/FILL-IN button before playing anything on the keyboard causes play to start with the variation pattern when something is played on the keyboard. · To cancel synchro start standby, press the SYNCHRO/ENDING button one more time. Use the number buttons or the [+]/[­] buttons to change the current volume setting value. Example: 110 NOTES · The current accompaniment volume value that appears in Step 1 automatically clears from the display if you do not input anything within about five seconds. · Pressing [+] and [­] buttons at the same time automatically sets an accompaniment volume of 075. Finishing with an Ending Pattern You can end your performances with an ending pattern that brings the rhythm pattern you are using to a natural-sounding conclusion. Note that the actual ending pattern played depends on the rhythm pattern you are using. Using One-touch Preset One-touch preset automatically makes the settings listed below in accordance with the rhythm pattern you are using. · Keyboard tone · Layer, Split, or Layer Split on/off · Layered tone (when layer is turned on), split tone (when split is turned on), or layered split tone (when layer and split are turned on) · Tempo · Accompaniment volume To finish with an ending pattern While the rhythm is playing, press the SYNCHRO/ENDING button. · This causes the ending pattern to play which brings rhythm accompaniment to an end. · The timing when the ending pattern starts depends on when you press the SYNCHRO/ENDING button. If you press the button before the second beat of the current measure, the ending pattern starts playing immediately. Pressing the button at any point in the measure after the second beat results in the ending pattern playing from the beginning of the following measure. To use one-touch preset 1. Press the ONE TOUCH PRESET button. · This automatically makes the one-touch preset settings in accordance with the rhythm you selected. Play a chord and the rhythm pattern starts to play automatically. · Accompaniment is played using the one touch preset settings. E-20 702A-E-022A Playing a Built-in Tune SONG BANK STOP PLAY/PAUSE [+]/[­] Number buttons A selection of 100 tunes come built-in for your listening enjoyment or play along fun. You can turn off the left-hand or right-hand part to practice with the remaining part, and the display even shows you what keys to press and which fingers you should use. · Song Bank: 50 Auto Accompaniment tunes · Etude: 20 piano lesson tunes · Concert Piece: 30 piano tunes 5. Press the PLAY/PAUSE button to start play of the tune. Chord name LAYER SPLIT ETUDE CONCERT PIECE GM TOUCH RESPONSE MEMORY To play back a Song Bank tune 1. 3. Find the tune you want to play in the SONG BANK List, and note its number. Press the SONG BANK button to enter the Song Bank Mode. Keyboard keys used Fingers used Staff display 6. Press the STOP button to stop playback of the Song Bank tune. Lit 4. Use the number buttons to input the tune's two-digit number. Example: To select "42 ALOHA OE", input 4 and then 2. Song number Song name NOTES · Tune Number 00 is the initial default Song Bank tune setting whenever you turn on keyboard power. · You can also increment the displayed tune number by pressing [+] and decrement is by pressing [­]. 702A-E-023A E-21 REW FF TONE Number buttons DEMO [+]/[­] START/STOP TEMPO PLAY/PAUSE STOP CONCERT PIECE ETUDE To play an Etude tune 3. 1. 2. Use the number buttons to input the two-digit tune number you looked up in step 1. Example: To select tune number 22 (FÜR ELISE), input 2 and then 2. Find the tune you want to play in the ETUDE List, and note its number. Press the ETUDE button to specify the Etude group. Lit ETUDE CONCERT PIECE Flash NOTE You can also change the displayed tune number using the [+] and [­] buttons. 3. Use the number buttons to input the two-digit tune number you looked up in step 1. Example: To select tune number 08 (Ode To Joy), input 0and then 8. 4. To stop playback, press the STOP button. NOTE Pressing the ETUDE button or CONCERT PIECE button changes the tone to grand piano (Tone Number 000). Musical Information System NOTE You can also change the displayed tune number using the [+] and [­] buttons. When the keyboard is playing one of its built-in tunes, the display shows a variety of information about the tune. [. . . ] Keyboard is waiting for play of the correct note during Step 1 or Step 2 play. Use the ACCOMP VOLUME button to increase the volume. Use the TRANSPOSE/TUNE/MIDI button to display the applicable setting screens and set both transpose and tuning to 00. (Track 2 is melody track. ) Use the TRANSPOSE/TUNE/MIDI button to display the SOUND RANGE SHIFT screen and correct the setting. Turn off the MIDI THRU function on the computer or turn off LOCAL CONTROL on the keyboard. [. . . ]