User manual CASIO CS-65P

[. . . ] â· Before assembling the stand, be sure to carefully read through the instructions contained in this manual. Symbols Various symbols are used in this operating manual and on the product itself to ensure that the product is used safely and correctly, and to prevent injury to the user and other persons as well as damage to property. This indication stipulates matters that have the risk of causing death or serious injury if the product is operated incorrectly while ignoring this indication. [. . . ] You should have a large Phillips head (+) screwdriver on hand for assembly. Do not throw away the packing material and keep it on hand for assembly. Check the items that come with the unit to make sure that everything shown in Figure 1 (A through I) is included. 1 1 Place the piano onto a blanket, pillow, or other soft object, and then remove the left and right end covers from the Keep the two black screws (v) from the left end cover on hand. You will not need the two screws from the right end cover for assembly, so keep them in a safe place in case you need them in the future. 2 Turn over the piano, insert the support piece A into the groove along the bottom ( 3 Break the polystyrene packing material into six pieces as shown in Figure 4. When assembling the stand, you should have the piano standing up with its back facing downwards. Use the six pieces of polystyrene foam to secure side panels C, D and back panel E in place. There should be some space between the edges of the side panels and the floor as shown in Figure 5. â· If you do not have any packing material available, use a magazine or some other thick item. Secure the side panel in place using the two black screws (v) that you removed From the left side cover (Figure 6). If you do, you will not be able to insert the back panel E in the following step. The holes in the joint connectors should be aligned with the holes in the back panel. â· Lift up back panel E so its screw holes align with the screw holes in the side panels, and then tighten the screws G. [. . . ] If you need to locate it away from a wall, be sure to perform the following steps in order to ensure that it is secure. 2 Repositioning the metal pieces so they are facing outwards reinstall them onto the side panels (Figure 8). If you have trouble inserting the bolts that come pre-installed in the side panels into the joint connector screw holes, use a screwdriver to rotate the joint connector so the bolts can enter the holes ( in Figure 8). [. . . ]