User manual CASIO 3053

[. . . ] MO0609-EA Operation Guide 3053 Getting Acquainted Congratulations upon your selection of this CASIO watch. To get the most out of your purchase, be sure to read this manual carefully. Your watch is shipped with it Auto Display feature (which continually changes the contents of the digital display) turned on. Calibration signal reception is disabled while Auto Display is turned on. [. . . ] · The DST indicator will appear whenever you display a city code for which Daylight Saving Time is turned on. · Note that the DST/Standard Time setting affects only the currently displayed city code. In the Alarm Mode, hold down A until the hour setting of the alarm time starts to flash, which indicates the setting screen. Press C to move the flashing between the hour and minute settings. 3. · When setting the alarm time using the 12-hour format, take care to set the time correctly as a. m. Press A to exit the setting screen. Countdown Timer Timekeeping Mode time (Hour : Minutes Seconds) Alarm Operation You can set the countdown timer within a range of one to 60 minutes. · All of the operations in this section are performed in the Countdown Timer Mode, which you enter by pressing C. The alarm sounds at the preset time for about 10 seconds (in all modes), or until you stop it by pressing any button. To test the alarm In the Alarm Mode, hold down D to sound the alarm. To turn the daily alarm and the Hourly Time Signal on and off In the Alarm Mode, press D to cycle through the settings shown below. Alarm On Indicator / Hourly Time Signal On Indicator Minutes Seconds To set the countdown start time 1. While the countdown start time is on the display in the Countdown Timer Mode, hold down A until the current countdown start time starts to flash, which indicates the setting screen. · If the countdown start time is not displayed, use the procedure under "To use the countdown timer" to display it. To use the countdown timer Press D while in the Countdown Timer Mode to start the countdown timer. · When the end of the countdown is reached, the alarm sounds for 10 seconds or until you stop it by pressing any button. The countdown time is reset automatically to its starting value after the alarm stops. · Press D while a countdown operation is in progress to pause it. · To stop a countdown operation completely, first pause it (by pressing D), and then press A. · Calibration signal reception is disabled while a countdown timer operation is in progress. · The alarm on indicator and the Hourly Time Signal on indicator are shown on the display in all modes while these functions are turned on. Timekeeping Use the Timekeeping Mode to set and view the current time and date. · When setting the time, you can also configure settings for the City Code, the DST setting, the 12/24-Hour Format, Year, Month, Day, the Language setting, and the Month/Day display format, and you can specify the screens that are displayed in the Timekeeping Mode. · Pressing D in the Timekeeping Mode will display the Last Signal screen. Current Time and Date Screen Last Signal Screen L Stopwatch Timekeeping Mode time (Hour : Minutes Seconds) Minutes Seconds 1/100 seconds The stopwatch lets you measure elapsed time, split times, and two finishes. · The display range of the stopwatch is 59 minutes, 59. 99 seconds. · The stopwatch continues to run, restarting from zero after it reaches its limit, until you stop it. [. . . ] When the setting you want is selected, press A to exit the setting screen. · The DST indicator appears to indicate that Daylight Saving Time is turned on. Reference This section contains more detailed and technical information about watch operation. It also contains important precautions and notes about the various features and functions of this watch. Auto Display Auto Display continually changes the contents of the digital display. To turn off Auto Display Press any button to turn off Auto Display. To turn on Auto Display In the Timekeeping Mode, while holding down B, hold down D for about two seconds until the watch beeps. Note · Calibration signal reception is disabled while Auto Display is being performed. [. . . ]