User manual CANON SELPHY CP510

[. . . ] User Guide Guía del usuario Guide d'utilisation ENGLISH ESPAÑOL FRANÇAIS CP710 CP510 NOTICE!When a computer is connected to the printer, be sure to install the software and the printer driver bundled on the supplied CD-ROM (Canon CP Printer Solution Disk). If you are using another version of software, actual screen contents and procedures may differ slightly from those indicated in this guide. Cuando se conecte un ordenador a la impresora, asegúrese de instalar el software y el controlador de la impresora incluidos con el CD-ROM suministrado (disco CP Printer Solution Disk de Canon). [. . . ] Be sure to close the middle cover and open the top cover so that output can proceed normally. ·Do not allow more than 9 sheets to accumulate in the print receptacle. Do not allow too many prints to accumulate. Print receptacle Do not remove the paper cassette while feeding, printing, or ejection is in progress. 29 Placing the Printer Usage Location "Usage Location" (p. Numbers in the figure correspond to the steps in the procedure below. 1 15 cm (6 in. ) at the front and back of the device and 10 cm (4 in. ) on both sides or more of open space 3 2 Compact power adapter To power outlet 4 The battery pack (sold separately) also can be used (p. 55). 1 2 3 4 Place the printer on a flat area. Connect the supplied power cord to the supplied Compact Power Adapter CA-CP200. Insert the plug in a power outlet. Connect the compact power adapter cable to the printer. 30 Connecting to a Camera for Printing Connecting to a Camera for Printing Connect the printer to the camera by the built-in retractable USB cable and start printing. This section explains the flow of printing operations with Canon cameras*. For more details, refer to your Camera User Guide or Direct Print User Guide. *In other cases, please refer to the "Printing with Non-Canon Digital Cameras" (p. 66). Make sure that the memory card is not inserted into the printer and that the printer is not connected to the computer. Use Canon cameras compatible with CP710/CP510, and non-Canon cameras compatible with PictBridge can also be connected. We recommend that you also connect the camera's compact power adapter (sold separately or included with the camera) when using the camera with your printer. If you wish to run the camera on battery pack or batteries power, be sure that battery pack is fully charged or the batteries are fresh. For details, please see the System Map that came with your camera. 1 Pull out the retractable USB cable from the printer, and connect to the camera. You can also use the USB cable included with the camera. In this case, connect the DIGITAL terminal on the camera to the direct print port (p. To retract the USB cable, pull the cable gently towards you and release the cable. Note that pulling the cable out beyond this length may damage it. 2 3 Press the printer's power button. The power button lights green once the printer powers up. Turn the camera's power on and display the images. Check that the (PictBridge) / (Canon Direct Print) icon is displayed in the upper left corner of the LCD monitor. When the icon is not displayed (p. 58) "Troubleshooting" Some camera models automatically power up when the cable is connected to the printer. The icon then displays on the LCD monitor. 31 4 5 Display the images to be printed and press the SET or SELECT button. If your camera has a (Print/Share) or immediately after you press the or (Direct print) button, printing starts button (Step 5 is not necessary). Select [Print] and press the SET or SELECT button. Printing starts. The camera returns to the playback screen once printing is successfully completed. If printing does not start, check the camera's LCD monitor for any messages (p. The screen shot differs depending on the model of your camera. Disconnect the camera Before you disconnect the camera from the printer, turn off the printer by holding down the power button until the green indicator goes out. Printing on the separately sold wide size (100 x 200 mm (4 x 8 in. )) paper The printing area may vary depending on the camera use. If appears in step 3 on page 31 If appears in step 3 on page 31 Printed on the whole card. Printed on the 100 x 150 mm (4 x 6 in. ) portion of the card. The upper and lower portions of an image are trimmed. Nothing is printed on this portion so you can write your message with an oil-based pen. If appears in step 3 on page 31, select [Default] on the paper size setting screen. 32 Printing from Memory Card (CP710 only) Insert the memory card into the printer so that you can print images stored on the memory card. Make sure that the camera or computer is not connected to the printer. Clearer printing results can be obtained when printing from a memory card by optimizing the information stored in the camera when the photo was taken. To turn image optimization off, press and hold the DATE button and then press the PRINT/ STOP button to start printing (p. [. . . ] Some images that have been recorded with another camera or modified using a computer cannot be printed. Convert the images as necessary to JPEG images that the camera can display. No Display Hardware Error Check whether or not an error other than a paper or ink error has occurred. 62 Printing from Memory Card (CP710 only) LCD monitor Cause/Solution The memory card is not loaded in the card slot. Insert a memory card recorded with images. You tried to print the following images. [. . . ]