User manual CANON PIXMA IP4500

[. . . ] Press the Open button to open the Paper Output Tray, and extend the Paper Output Tray Extension. Caution Before turning on the printer, remove all the shipping tapes. 2 Install the Print Head d Open the Top Cover. The Print Head Holder moves to the center. Top Cover 3 Install the Ink Tanks Note For the ink tanks compatible with this printer, refer to the back cover of the Quick Start Guide. 4 Load Printing Paper Important Once you have installed the ink tanks, the POWER lamp will flash green. Wait for about 2 minutes, until the POWER lamp stops flashing and changes to steady, non-flashing green and the printer has stopped making operating noises, before proceeding. a Remove the Print Head from its package. a the orange tape in the direction of Pull the arrow to peel off the protective film and remove the film completely. a Pinch the Paper Guide and slide it Caution There may be some transparent or light blue ink on the inside of the bag the print head comes in, or the inside of the protective cap - this has no effect on print quality. [. . . ] · Do not open the Top Cover and Inner Cover while printing. The pattern is printed, and the Print Head is aligned automatically. a Be sure to TURN THE PRINTER OFF before continuing. (1) Press the POWER button. (2) Make sure that the POWER lamp stops flashing. b Turn the computer on and start Windows. Important If the Found New Hardware or Found New Hardware Wizard screen appears automatically, remove the USB cable connected to your computer. In Windows Vista, the screen may close automatically when the USB cable is unplugged. Then turn off the printer and proceed from step c to install the printer driver. Note · Print Head Alignment will take about 13 minutes to complete. · When Automatic Print Head Alignment cannot be executed properly, the ALARM lamp on the printer will flash orange eleven times. Refer to "ALARM Lamp Flashes Orange" in "Troubleshooting" of the Quick Start Guide. The pattern is printed, and the Print Head is aligned automatically. USB b Turn on your Mac and insert the Setup CD-ROM. Note If the CD-ROM folder does not open automatically, double-click the CD-ROM icon on the desktop. k When the Setup Complete screen appears, click Next. l When the User Registration screen appears, click Next. Note To register later, click Cancel and go to Step m. After software installation is complete, double-click on the desktop. c Double-click the Setup icon. The setup program should run automatically. In Windows Vista, go to Step d. In Windows XP and Windows 2000, go to Step f. Note · The pattern is printed in black and blue. · When Automatic Print Head Alignment cannot be executed properly, the ALARM lamp on the printer will flash orange eleven times. Refer to "ALARM Lamp Flashes Orange" in "Troubleshooting" of the Quick Start Guide. d When the Authenticate screen appears, enter your d If the AutoPlay screen appears, click Run Msetup4. exe. e If the User Account Control screen appears, click Continue. If the same screen reappears in subsequent steps, click Continue. k After print head alignment is completed, click Next. [. . . ] i When the Printer Connection screen appears, confirm the displayed message and click Restart. The system is restarted automatically. Note Do not remove the Setup CD-ROM while your computer is being restarted. Software installation and print head alignment are now complete. i When the Printer Connection screen appears, connect one Part no. "Microsoft" is a registered trademark of Microsoft Corporation. "Windows" is a trademark of Microsoft Corporation, registered in the U. S. [. . . ]