User manual CANON PIXMA IP3500

[. . . ] Open the Front Tray, and extend the Output Tray Extension. Caution Before turning on the printer, remove all the shipping tapes. 2 Install the Print Head a Remove the Print Head from its package. 3 Install the Ink Tanks e Push the Print Head to hold it in place, and lower the Print Head Lock Lever carefully. Note For the ink tanks compatible with this printer, refer to the back cover of the Quick Start Guide. e Close the Top Cover. a Pull the orange tape in the direction of the arrow to peel off the protective film and remove the film completely. This printer offers two paper sources to load printing paper; the Rear Tray, found at the top of the printer, and the Front Tray, found at the front of the printer. Note · At purchase, the printer is set to feed from the Rear Tray. If you are printing without changing paper source settings, load paper in the Rear Tray. [. . . ] After software installation is complete, double-click on the desktop. do W in M ac in to h Read the License Agreement carefully and click Yes. The Note · The screens below refer to Windows VistaTM operating system Ultimate Edition (hereafter referred to as "Windows Vista") installation. · Before installing the software, disable all anti-virus programs and automatically loading programs. · A message asking for your confirmation to restart your computer may appear during the installation process. If this message is displayed, follow the on-screen instructions and click OK. The installation resumes from where it left off when your computer has been restarted. · If the computer is restarted during installation, do not remove the Setup CD-ROM during restarting. software installation screen may appear during the installation process. end of the USB cable to the computer, the other to the printer, then TURN THE PRINTER ON. The printer driver will begin identifying the printer port being used. Important If you cannot go to the next procedure after 2 minutes, refer to "Troubleshooting" instructions in the Quick Start Guide. i When the Printer Connection screen appears, connect one Note · Since Mac® OS 9, Mac OS X Classic environments, or Mac OS X v. 10. 2. 7 or earlier are not supported, do not connect the printer to these. · Before installing the software, disable all anti-virus programs and automatically loading programs. Follow on-screen instructions to register your product. You will need your product serial number, which is located on the inside of the printer. a Connect one end of the USB cable to the computer, the other to the printer. Note Make sure the printer is turned on. Serial Number k When the Installation completed successfully screen appears, click Restart. Remove the CD-ROM after clicking Restart and restarting the computer. Note Keep the CD-ROM in a safe place in case you need to reinstall the software. a Be sure to TURN THE PRINTER OFF before continuing. (1) Press the POWER button. (2) Make sure that the POWER lamp stops flashing. b Turn the computer on and start Windows. Important If the Found New Hardware or Found New Hardware Wizard screen appears automatically, remove the USB cable connected to your computer. In Windows Vista, the screen may close automatically when the USB cable is unplugged. Then turn off the printer and proceed from step c to install the printer driver. To Computer USB When the Print Head Alignment Recommended screen appears, click Next. USB j When the Installation Results screen appears, click Next. b Turn on your Mac and insert the Setup CD-ROM. Note If the CD-ROM folder does not open automatically, double-click the CD-ROM icon on the desktop. The system is restarted automatically. Note If straight lines are misaligned or print quality is not satisfactory after installing the printer driver, you may need to align the Print Head. [. . . ] "Microsoft" is a registered trademark of Microsoft Corporation. "Windows" is a trademark of Microsoft Corporation, registered in the U. S. [. . . ]