User manual CANON PIXMA MP610

[. . . ] The Print Head Holder moves to the center. 3 Install the Ink Tanks Note For the ink tanks compatible with this machine, refer to the back cover of the Quick Start Guide. 4 Align the Print Head a Pinch the Paper Guide and slide it to the left end. Paper Support Extension Paper Guide a Remove the Print Head from its package. a Pull the orange tape in the direction of the arrow to peel off the protective film and remove the film completely. Print Head Ink Tanks Caution There may be some transparent or light blue ink on the inside of the bag the print head comes in, or the inside of the protective cap - this has no effect on print quality. Be careful not to get ink on yourself when handling these items. Important The Print Head and ink tanks are placed inside of the Paper Output Tray. b Remove the orange protective cap from the Print Head and discard it. Electrical Contacts If the air hole is blocked with the remaining film, ink may leak out or may not eject properly. b Twist off and discard the orange protective cap located on the bottom of the ink tank. Do not press! [. . . ] The installation resumes from where it left off when your computer has been restarted. · If the computer is restarted during installation, do not remove the Setup CD-ROM during restarting. g When the list of applications to install appears, confirm the contents and click Install. Note Move the cursor over items to display explanations of each application. h Read the License Agreement carefully and click Yes. The software installation screen may appear during the installation process. one end of the USB cable to the computer, the other to the machine, then TURN THE MACHINE ON. The software will begin identifying the printer port being used. Important If you cannot go to the next procedure after three minutes, refer to "Troubleshooting" instructions in the Quick Start Guide. Note · Since Mac® OS 9, Mac OS X Classic environments, or Mac OS X v. 10. 2. 7 or earlier are not supported, do not connect the machine to these. · Before installing the driver, disable all anti-virus programs and automatically loading programs. i When the User Registration screen appears, click Next. Note To register later, click Cancel and go to Step j. After software installation is complete, double-click on the desktop. a Connect one end of the USB cable to the computer, the other to the machine. Note Make sure the machine is turned on. Follow the on-screen instructions to register your product. You will need your product serial number, which is located on the inside of the machine. See Step 1- f on the front page. i When the Printer Connection screen appears, connect j When the Installation completed successfully screen appears, click Restart. Remove the CD-ROM after clicking Restart and restarting the computer. Note Keep the CD-ROM in a safe place in case you need to reinstall the software. a Be sure to TURN THE MACHINE OFF before continuing. (1) Press the ON/OFF button. (2) Make sure that the Power lamp stops flashing. b Turn the computer on and start Windows. Important If the Found New Hardware or Found New Hardware Wizard screen appears automatically, remove the USB cable connected to your computer. In Windows Vista, the screen may close automatically when the USB cable is unplugged. Then turn off the machine and proceed from step c to install the MP Drivers. USB b Turn on your Mac and insert the Setup CD-ROM. USB To Computer The system is restarted automatically. When using Mac OS X v. 10. 2. 8 to v. 10. 3. 3: Restarting the computer while connected to the machine may cause the machine not to be detected. To resolve this, either unplug the USB cable then plug it back in again, or turn the machine off then back on again. Note · When using Mac OS X v. 10. 2. 8 to v. 10. 3. x, before using the Operation Panel on the machine to save originals scanned from the Platen Glass to the computer, it is necessary to select MP Navigator EX as the launch application on Image Capture under Applications. [. . . ] Follow the on-screen instructions to install the software. h When the Setup Complete screen appears, click Next. Software installation is now complete. Note If you want to select particular items to install, click Custom Install and follow the onscreen instructions to proceed the installation. "Microsoft" is a registered trademark of Microsoft Corporation. [. . . ]