User manual CANDY CMCH202EL

[. . . ] Before using your refrigerator, please carefully read this instruction manual in order to maximize its performance. This appliance must be used only for purposes of storage of food, any other use is considered dangerous and the manufacturer will not be responsible for any omissions. Also, it is recommended that you take note of the warranty conditions. Please, to obtain the best possible performance and trouble free operation from your appliance it is very important to carefully read these instructions. [. . . ] Climate class of your appliance is indicated on the label with technical description inside the fridge compartment. (°F) From 50 to 90 From 61 to 90 From 61 to 100 From 61 to 110 TRANSPORTATION INSTRUCTIONS The appliance should be transported only in a vertical upright position. If during the course of transport the product has been transported horizontally, it must only be laid on its left hand side (when facing the door front) and it must not be operated for at least 4 hours to allow the system to settle after the appliance is brought back to upright position. Failure to comply with the above instructions could result in damage occurring to the appliance. The manufacturer will not be held responsible if these instructions are disregarded. The appliance must be protected against rain, moisture and other atmospheric influences. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances: From Cookers From Radiators From Fridges 4" (100 mm) 12" (300 mm) 4" (100 mm) 2. Make sure that sufficient room is provided around the appliance to ensure free air circulation. Ideally, A space of no less than 10cm must be left around the freezer, and ensure you allow gaps as shown in the below diagram. Do not locate the freezer in moist space to avoid the metal parts rusty. And do not spray water to the freezer, otherwise it will weaken the insulation and causes current leakage. Refer to "Cleaning and Care" section to prepare your appliance for use. STARTING TO USE Before you starting to use the freezer, please check that: 1. Insert the plug into the wall socket, all LED lights, digital display light returned to normal after 2s. ; enter to modify status without any operation after 5s, automatically locked 4. The liquid and gases sealed within the refrigeration system may also give rise to noise, wheter the compressor is running or not which is quite normal. If you going to store already frozen food open the freezer lid and check that the freezer has reached correct temperature. Then you can put in your already frozen food (see “Storing Frozen Food”). We recommend that you check the temperature with an accurate thermometer (see “Freezer Operation”). FREEZER OPERATION Unlock Settings Hold the “+” key and “-” key, both at the same time for more than 1s to unlock function, temperature setting, quick-frozen setting function.  Every press “Up” key, 1°C temperature increase; every press “Down”, 1°C temperature decrease; when the stop button operation after the 5s system automatically according to the set temperature, automatic confirmation and exit, stop flashing. [. . . ] The plug is inserted properly in the socket and that the power supply is on. The fuse has blown/circuit breaker has tripped/main distribution switch has been turned off. If the provided plug has been replaced, make sure the new plug is properly connected. If the appliance is still not operating after the above checks, please contact Customer Service. [. . . ]