User manual CALIBER RCD 212BTI

[. . . ] Thank you for purchasing this high-technology car stereo with CD/MP3 and USB, SD/MMC control. also it supports up to 8GB storage size of USB flashdisk and SD/MMC media storage. If there is any compatibility problems, we recommend you to format your flashdisk/storage card in FAT3 mode before using it.  Owner’ Manual RCD 212BTi MANUAL Precautions • This unit will only play the following discs. [. . . ] €¢ This unit is designed for use with four (4) speakers with impedance between 4 Ohms to 8 Ohms. €¢ An impedance load of less than 4 Ohms could damage the unit • Never bridge or combine the speaker wire outputs. When not using four speakers, use electrical tape to tape the ends of the unused speaker outputs to prevent a short circuit. Pairing Press and hold PHONE button until the word “PAIRING” blinks on the display waiting for the bluetooth device to connect. At this blinking time, please run the bluetooth search and connect function in your cell phone. The car radio model no “BT Car Stereo” will be shown on the cellphone . When you are asked for a connection password, please input “0000” in your cellphone to finish the pairing, there is “PAIR OK” to show on the LCD. Bass Press the SEL Button repeatedly until the display shows "BAS". Treble Press SEL Button repeatedly until the display shows "TRE". Balance Press SEL Button repeatedly until the display shows "BAL", then use the VOL +/- Button to adjust the balance between the left & right speakers. Fader Press SEL Button repeatedly until the display shows "FAD", then use the VOL +/- Button to adjust the balance between the front & rear speakers. Press the CLK/DISP Button on the faceplate or remote control once (press and hold for more than  seconds during radio mode), the time will show on the display. Rotate the VOL knob to set hours, then press the VOL knob for the minutes to blink and rotate the VOL knob to set. Press the CLK/DISP button again or leave the unit idle for new setting to effect. Preset Beep Sound Off Press the SEL button repeatedly until “BEEP ON” is displayed. Turn the VOL +/- Button to select "BEEP OFF" or "BEEP ON", then leave the unit idle for setting to take effect. Preset Equalizer Function Press the SEL Button repeatedly until “EQ” indication is displayed then rotate the Volume knob to choose between the EQ sound effects. the Sequence of equalizer setting will be as follows: OFF FLAT POP ROCK CLASSIC 13. Dual Color Select (Optional) Press the SEL knob repeatedly until the display shows “Color 1” or “Color  ” Turn the volume knob to select between “Color 1” or “Color  ” . 14 Owner’ Manual RCD 212BTi • MANUAL Radio Operation 1. The unit comes with five bands- three FM Bands (FM1, FM, and FM3) and two MW Bands (MW1, and MW) selects. Each of the five bands can store up to six preset stations, for a total of 30 preset memory stations. [. . . ] Press and hold the SEL button for  seconds, the number of the track is assigned according to you added the file into the media. Folder Search Press the F/PS Button twice and NAVIGATE will be shown on the display. Electronic Skip Protection Electronic Skip Protection is for driving on rough roads. If the road is rough for more than 10 seconds the CD with MP3 or WMA files may skip. [. . . ]