User manual BRAUN SERIES 5 590

[. . . ] The cleaning cartridge contains a highly flammable liquid so keep it away from sources of ignition. Do not expose to direct sunlight and cigarette smoking nor store it over a radiator. Do not refill the cartridge and use only original Braun refill cartridges. shaver 1 Foil & Cutter cassette 2 Cassette release button 3 MultiHeadLock switch 4 On/off switch 5 Shaver display 6 Long hair trimmer 7 Shaver-to-station contacts 8a Release button for long hair trimmer 8b Model number of shaver 9 Shaver power socket 10 Special cord set 11a Brush 11b Hard travel case 11c Protection cap first use and Charging Prior to first use remove the protection foil from the shaver display and connect the shaver to an electrical outlet using the special cord set (10). [. . . ] Slide the cartridge from the rear side into the base Of the station until it snaps into place. Important: The shaver needs to be dry and free from any foam or soap residue!The contacts (7) on the back of the shaver need to align with the contacts (14) in the station. Model 5090cc: The Clean&Charge Station analyzes the hygiene status. The status is shown by the cleaning program indicators in the Clean&Charge Station display (15) more details see chapter «Cleaning programs» below. When the cleaning indicator lights up in the shaver display, insert the shaver into the Clean&Charge Station, upside down and with the front showing (with released head lock/contact alignment/beep sound). cleaning programs 5090cc: The hygiene status will be analyzed and one of the following program indicators will light up. Short economical cleaning normal level of cleaning high intensive cleaning Start the cleaning process by pressing the start button (16). If status light (15a) does not shine (Clean&Charge Station switches to stand-by after ca. Each cleaning program consists of several cycles, where cleaning fluid is flushed through the shaver head. Depending on your Clean&Charge Station model and/or program selected, the cleaning time takes up to 3 minutes. During this time the status light Leave the shaver in the station for drying. It takes several hours until remaining moisture evaporates depending on the climatic conditions. After completing the cleaning and charging procedure, all indicators turn off. e) Hold the Clean&Charge Station with one hand and tilt the shaver slightly to the front to release it. When the level indicator lights up permanently red, the remaining fluid in the cartridge is sufficient for about 3 more cycles. When the level indicator blinks red, the cartridge needs to be replaced about every 4 weeks (when used daily). After having pressed the lift button (13) to open the housing, wait for a few seconds before removing the used cartridge to avoid any dripping. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. The hygienic cleaning cartridge contains ethanol or isopropanol (specification see cartridge), which once opened will naturally evaporate slowly. Each cartridge, if not used daily, should be replaced after approximately 8 weeks to ensure optimal disinfection. The cleaning cartridge also contains lubricants for the shaving system, which may leave residual marks on the outer foil frame and the cleaning chamber of the Clean&Charge Station. [. . . ] Local Service Agents may change from time to time ­ in that event please contact the Consumer Service free call number below for updated local service agent details. Clean&Charge-stationen (model 5090cc/5070cc/5050cc) Sørg for, at Clean&Charge-stationen er placeret på en plan overflade for at forhindre lækage af rengøringsvæske. Tryk på start/stop-knappen (4) for at tænde for barbermaskinen. Sluk så for barbermaskinen, tryk på udløserknapperne (2) for at fjerne kassetten med skæreblade og lamelknive (1), og lad den tørre. [. . . ]