User manual BOSCH SPS53M52EU

[. . . ] Switching off automatically after the end of the programme Switching off the appliance . 25 Intended use dn et nI e s u Overall condition of the machine Special salt and rinse aid . 40 This appliance is intended for use in the home and the home environment. Use the dishwasher only in the household and only for its designed purpose: for washing domestic dishes. Safety instructions yf tS e a sic nusi otrtn . [. . . ] Press button P until the displayed time corresponds with your requirements. To delete the preselected starting time, press the button P until is indicated on the digital display. You can change your programme selection at any time until the programme starts. Switching off automatically after the end of the programme * Switchingof automaticalyafterthe ndoftheprogram e End of programme The programme has ended when the value : is indicated on the numerical display H. * depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). : Appliance does not switch off automatically : Off after 1 min : Off after 120 min 1. Rotate programme selector 8 until the required value is indicated on the digital display H. The set value is saved. Switching off the appliance Short time after the end of the programme: 1. Remove the utensils when they have cooled down. 23 en Operating the appliance Note When the programme ends, leave the appliance to cool down a while before opening it. This will prevent steam from escaping and causing longterm damage to your built-in furniture. Changing the programme When the START button @ has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Interrupting the programme 1. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. To continue the programme, switch on the ON/OFF switch ( again. Intensive drying The final rinse uses a higher temperature which improves the drying result. Rotate programme selector 8 until : is indicated on the digital display H. The factory-set value : is lit on the digital display H (intensive drying off). By rotating the programme selector 8, you can switch intensive drying on : or off : . The set value is saved. Terminatingtheprogram e Terminating the programme (Reset) 1. Switch off ON/OFF switch (. 24 Cleaning and maintenance en Cleaning and maintenance gC ne i nl a d n a en cm nti aa e A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Overall condition of the machine Check spray arm for grease and limescale deposits. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. To ensure that the door seal always remains clean and hygienic, regularly clean it with a damp cloth and a little washing-up liquid. If the appliance is switched off for a prolonged period, leave the door ajar to prevent the formation of an unpleasant odour. Never use a steam cleaner to clean your dishwasher. [. . . ] Connect the waste-water hose to the drainage connection of the siphon with the enclosed parts. Ensure that the drainage hose is not kinked, crushed or twisted and that there is no cover plate in the drainage to prevent the waste water from flowing out! 37 en Installation and connection Drinking water connection 1. Fasten the drinking water connection to the tap according to the installation instructions using the enclosed parts. Ensure that the drinking water connection is not kinked, crushed or twisted. [. . . ]