User manual BOSCH SMU4ECS14E

[. . . ] We will only be liable for damages if the repair hints have been followed properly. Non-observance of the warning message will result in death or serious injuries. Non-observance of the warning message could result in death or serious injuries. Non-observance of the warning message could result in damage to property. [. . . ] 1 Installing a tab slide for the 86 cm model Insert the tab slide diagonally at the front of the basket. The additional angle reduces the collection of water on the bottom of cups. In the case of tall glasses we recommended leaving the cup support clip folded down. If upper baskets have an optional plastic insert, they must first be removed. Press plastic side inserts outwards and press them upwards out of the frame. Turn the coarse filter anticlockwise (1) and remove the filter system (2). Make sure that the locking catches on the coarse filter click into position. Insert the filter system into the appliance and turn the coarse filter clockwise. Insert the baking sheet spray head in the holder (1) and turn to the right (2). Move the plug of the power cord carefully up and down and pull it out of the mains socket. Insert the plug of the power cord into the mains socket until the plug clicks audibly into place. Lever the detergent cover on the lower side out of the guide rails and take the de- Tergent cover on the upper side out of the guide rails. Insert the long end of the spring into the mounting hole of the dispenser device (1). Insert the short end of the spring into the mounting hole of the detergent cover (2). Insert the detergent cover 5 mm before the completely open position into the guide rails on one side. damage to cabling Position the cables and secure in place with adhesive tape. Prerequisite: Insulating fleece has been correctly positioned and fixed on the inside of the outer door. Open the door and secure it with two screws (4 x 11 mm metal screws). If an operating module is defective, the entire control panel must be replaced. Disconnect electrical connections from the control panel and the low rinse-aid sensor (1, 2). [. . . ] This is 1750 mm for appliances of 81 cm in height and 1850 mm for appliances of 86 cm in height. The EmotionLight is situated in the upper front exterior area of the rinsing tank. Install the cable in the area of the door hinge (between the plate hinge and the rinsing tank) so that it cannot be damaged by moving parts. Lift up PCB with holder and remove it from operation module frame (2). [. . . ]