User manual BOSCH SMS69N48EU

[. . . ] 24 Intended use dn et nI e s u Overall condition of the machine Special salt and rinse aid . 38 This appliance is intended for use in the home and the home environment. Use the dishwasher only in the household and only for its designed purpose: for washing domestic dishes. Safety instructions yf tS e a sic nusi otrtn . 38 Children from 8 years of age or people whose physical, sensory or mental abilities or their lack of experience or knowledge prevent them from using the appliance safely must not use this appliance without supervision or instruction by a responsible person. [. . . ] If the Aqua sensor is active, “clean” rinsing water can be transferred to the next rinse bath and water consumption can be reduced by 3–6 litres. If the turbidity is greater, the water is drained and is replaced with fresh water. In the automatic programmes the temperature and running time can also be adjusted to the degree of soiling. Programme sequence indicator )" Program esequenceindicator -/, Your dishes are being cleaned. =/< Your dishes are being dried. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display )*. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). Switching on the appliance 1. This programme remains selected if no other programme button 0 is pressed. The programme starts running. 21 en Timerprogram ing Operating the appliance Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. Press X + or – button until the displayed time corresponds with your requirements. To delete timer programming, press the X + or – button until )* : is indicated on the digital display. You can change your programme selection at any time until the programme starts. Automatic switch off after end of programme or interior light* Automaticswitchof /interiorlight End of programme The programme has ended when the value : is indicated on the numerical display )*. * depending on model To save energy, the dishwasher can be automatically switched off 1 min or 120 min after the programme ends. The interior light 1" comes on when the door is opened irrespective of whether the ON/OFF switch ( is switched on or off. If the door is open for longer than 60 min. , the light switches off automatically. The interior light 1" is lit only when the set value : is selected. The LED for button # flashes and the digital display )* displays the factory setting : . is indicated on the numerical display )*. 22 Operating the appliance To change the setting: 1. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : . The set value is saved. Terminatingtheprogram e en Terminating the programme (Reset) Switching off the appliance Short time after the end of the programme: 1. Note When the programme ends, leave the appliance to cool down a while before opening it. This will prevent steam from escaping and causing longterm damage to your built-in furniture. 1. Switch off ON/OFF switch (. Changing the programme When the START button h has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. Hold down programme button # and press START button h until the digital display )* : . . . [. . . ] The required work sequence can be found in the installation instructions. Connect the waste-water hose to the drainage connection of the siphon with the enclosed parts. Ensure that the drainage hose is not kinked, crushed or twisted and that there is no cover plate in the drainage to prevent the waste water from flowing out! 36 Installation and connection en Drinking water connection 1. Fasten the drinking water connection to the tap according to the installation instructions using the enclosed parts. [. . . ]