User manual BOSCH SMI 40D02EU/14 INSTALLATION INSTRUCTIONS

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BOSCH SMI 40D02EU/14. We hope that this BOSCH SMI 40D02EU/14 user guide will be useful to you.


BOSCH SMI 40D02EU/14 INSTALLATION INSTRUCTIONS: Download the complete user guide (1274 Ko)

You may also download the following manuals related to this product:

   BOSCH SMI 40D02EU/14 (2319 ko)
   BOSCH SMI 40D02EU/14 SUPPLEMENT (740 ko)

Manual abstract: user guide BOSCH SMI 40D02EU/14INSTALLATION INSTRUCTIONS

Detailed instructions for use are in the User's Guide.

[. . . ] If your dishwasher is damaged, you should contact your supplier. q Your dishwasher must be correctly installed and connected. Please read the section on "Installation" to make sure you know all about this. Before using your dishwasher for the first time, do not forget that the nominal voltage and current type indicated on the rating plate of your machine must be the same as the nominal voltage and current type at the installation site. The necessary electrical fusing is also given on the rating plate. q Child safety q Packaging parts (e. g. [. . . ] Your local Water Company will provide you with information about water hardness in your area. Water hardness Programme Programme "INTENSIVE 70°" Programme "NORMAL 65°" Programme "NORMAL BIO 50°" Programme "QUICK 50°" Programme "RINSE AND HOLD" 14 Level level 0 level 1 level 2 level 3 level 4 °dH German degrees °TH French degrees ppm (parts per million) Use of salt 0-4 5-11 12-22 23-39 40-50 0-8 9-20 0-80 81-200 NO YES YES YES YES 21-40 201-400 41-70 401-700 71-90 701-900 The dishwasher is factory set "level 4" as this suits most users. You are reminded of this by the salt refill indicator light on the control panel which will illuminate when the salt has finished. Important: The salt refill indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuring the dishwasher remains on. If you are using salts that take longer to dissolve then this can take longer. The function of the dishwasher is not affected. 16 Caution: Only fill with salt just before starting one of the complete washing programmes (not the RINSE AND HOLD programme). This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time, which could cause corrosion. The rinse-aid The rinse-aid ensures brilliant crockery and also helps it to dry. The storage compartment built in to the in side of the door can hold about 110 ml of rinse-aid, which will be sufficient for between 16 and 40 dishwashing programmes, according to the dosage setting. Filling up the rinse-aid Open the container by turning the lid (A) anticlockwise (Fig. Pour the rinse-aid into the filler opening until the indicator (B) on the side of the cover turns completely dark (i. e. until the container is full) B m a x 6543 21 A BR01 BR03 Rinse aid replenishment indicator Top up with rinse aid when the rinse aid control light on the control panel flashes (approx. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. 17 Setting the rinse aid quantity to be added The correct dosage of the rinse-aid should be regulated on the basis of the shine and drying results. This makes it easier to remove small pieces of cutlery. 22 Important note!To prevent the full cutlery basket from inadvertently unfolding when being taken out, place your hand right round the two-piece handle and hold it firmly. Ë Place the cutlery basket on a firm support (table, worktop) and unfold both handle parts. UI20 UI25 Ë After unfolding, fold back both handle parts. Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. 23 The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates up to 24 cm in diameter), salad bowls, cups and glasses; these should be arranged as shown in the pictures. Glasses with long stems can be placed upside-down in the raised cup-racks US08 IEC 436 / DIN 44990 US07 The cup-rack on the left folds upwards to increase your loading flexibility. Before closing the door, ensure that the spray arms can rotate freely. 24 Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position as follows: Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. A RC01 When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use raised cup racks. 25 Operating instructions Set and start the programme Push the plug into the socket. The indicator lights corresponding to the programme and the phases of the programme will illuminate. The control lights of "rinse aid" and "salt" may also illuminate if refilling is necessary. Until the door is partially or totally opened you are still able to modify or change the setting of the programme; by simply pressing the on/off pushbutton. After 5 seconds the selected programme will start (it is still possible to change the setting of the programme if you press the on/off pushbutton within these 5 seconds). The lights corresponding to the phases of the cycle will turn off except the light of the phase under way. At the end of the programme The machine stops automatically. [. . . ] Note: The panel should be fitted before positioning the machine. For built-in appliances only Please consult the enclosed template with the installation instructions. Please note the following before installing: When the door is opened after the programme has ended, steam escapes from the machine as a normal operation feature and may cause nonwatertight bonded worktops to swell and warp. In all cases, this must be properly arranged to prevent subsequent damage to the worktop. the protection should be arranged according to the instructions given on the template. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BOSCH SMI 40D02EU/14




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BOSCH SMI 40D02EU/14 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.