User manual BOSCH MUM59343

[. . . ] Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Cleaning and user maintenance must not be performed by children unless they are supervised. Connect and operate the appliance only in accordance with the specifications on the rating plate. Only use the appliance indoors at room temperature and up to 2000 m above sea level. [. . . ] Do not change tools until the drive has come to a standstill ­ when the appliance is switched off, the drive continues running briefly and stops in the tool change position. For reasons of safety the appliance may only be operated when unused drives have been covered with drive guards (5, 8). Professional beating whisk (14) for whisking egg whites, cream and light dough, e. Kneading hook (15) for kneading heavy dough and mixingin ingredients that ought not be cut (e. Important information concerning the use of the whisk Figure E: The whisk should almost touch the bottom of the bowl to ensure that the ingredients are optimally mixed. hold whisk in place and loosen nut clockwise using open-ended wrench (size 8). Set the whisk to the optimum height by rotating the whisk: ­ Turn clockwise: Raise ­ Turn anti-clockwise: Lower Press the Release button and move the swivel arm to position 1. When the height has been set correctly, press Release button and move the swivel arm to position 2. hold whisk in place and tighten nut anticlockwise using open-ended wrench (size 8). Working with the bowl and the tools Figure F: Press the Release button and move the swivel arm to position 2. Depending on the processing task, insert the stirrer, whisk or kneading hook until it locks into position. Note: If using the kneading hook, rotate the dough deflector until the kneading hook can lock into position (Fig. Put the ingredients to be processed into Set the rotary switch to the desired setting. Our recommendation: ­ Professional flexi stirring whisk: First mix at setting 1-2, then setting 3-5 as required ­ Professional beating whisk: setting 7, mix in at setting 1 ­ Kneading hook: first stir in at setting 1, knead at setting 3 Adding more ingredients Switch off the appliance with the rotary switch. Add more ingredients through the feed After using the appliance Switch off the appliance with the rotary Take the tool out of the drive. continuous-feed shredder WWRisk of injury Do not grip the sharp blades or edges of the cutting discs. Before attaching / removing the continuous-feed shredder, wait until the drive has come to a standstill and pull out the mains plug. Operate the continuous-feed shredder in the indicated operating position only. Predetermined breaking point Figure G: The built-in predetermined breaking point protects the drive of the appliance. If an overload occurs, the drive shaft of the continuous-feed shredder breaks. A new disc holder with drive shaft is available from customer service. Designation on the reversible slicing disc: "Grob" for the coarse cutting side "Fein" for the fine cutting side warning! [. . . ] Betegnelse på vendeskæreskiven: , , Grob" (grov) for den tykke skæreside , , Fein" (fin) for den tynde skæreside Betegnelse på venderiveskiven: , , 2" for den grove riveside , , 4" for den fine riveside For din egen sikkerhet Les nøye igjennom denne veiledningen før bruk, for å få viktige sikkerhets- og betjeningshenvisninger for dette apparatet. Dersom det ikke blir tatt hensyn til henvisningene for riktig bruk av apparatet, er produsenten ikke ansvarlig for skader som oppstår på grunn av dette. 7 Drev for verktøy (rørepinne, visp, eltekrok) og kjøttkvern (spesialtilbehør*) 8 Beskyttelseslokk for mikserdrevet 9 Beskyttelseslokk for mikserdrevet (spesialtilbehør*) Når det ikke er i bruk, må beskyttelseslokket settes på mikserdrevet. Profi visp (14) for pisking av eggehvite, fløte og for pisking av lette deiger, f. [. . . ]