User manual BEKO FNE20921

[. . . ] €¢ Keep the manual in an easily accessible place as you may need it later. €¢ Besides, read also the other documents provided with your product. Symbols and their descriptions This instruction manual contains the following symbols: C A B Important information or useful usage tips. Recycling This product is supplied with the selective sorting symbol for waste electrical and electronic equipment (WEEE). [. . . ] Please do not forget… Every recycled material is an indispensable source for the nature and for our national resources. If you wish to contribute to recycling the packaging materials, you can get further information from the environmental bodies or local authorities. Clean the interior of the refrigerator as recommended in the “Maintenance and cleaning” section. The liquid and gases sealed within the refrigeration system may also give rise to noise, even if the compressor is not running and this is quite normal. These areas are designed to be warm to avoid condensation Electric connection Before operating your refrigerator Before starting to use your refrigerator check the following: 1. Is the interior of the refrigerator dry and can the air circulate freely in the rear of it?Plastic wedges will provide the required distance between your refrigerator and the wall in order to allow the air circulation. (The illustrated figure is only an example and does not match exactly with your product. ) 8 Connect your product to a grounded socket which is being protected by a fuse with the appropriate capacity. Important: • The connection must be in compliance with national regulations. €¢ The power cable plug must be easily accessible after installation. Lower temperatures can be obtained by adjusting the thermostat knob towards Position MAX. We recommend checking the temperature with a thermometer to ensure that the storage compartments are kept to the desired temperature. Remember to take the reading immediately since the thermometer temperature will rise very rapidly after you remove it from the freezer. Indicator lights There are three coloured indicator lights located inside the appliance which show the operating mode of the freezer. Amber Indicator Illuminates when the thermostat knob is turned to MAX. position and stays on until the fast freeze operation is deactivated manually. Green Indicator Illuminates when the appliance is connected to the mains and will glow as long as there is electricity present. The green indicator does not give any indication of the temperature inside the freezer. Red Indicator High Temperature Alarm After the appliance is turned on for the first time the alarm is not active for 12 hours (The red LED indicator is switched off). After this period of time the red LED indicator is switched on in the following situations: -If the appliance is overloaded with fresh food -If the door is left open by mistake. In these situations the red LED indicator will continue to be switched on until the appliance reaches the preset temperature. [. . . ] • The refrigerator is adjusted to a very low temperature. Adjust the refrigerator temperature to a warmer degree and wait until the temperature is achieved. €¢ Door seal of the fridge or freezer may be soiled, worn out, broken or not properly seated. Damaged/broken seal causes the refrigerator to run for a longer period of time in order to maintain the current temperature. [. . . ]