User manual BAUKNECHT GXU7130DXS

[. . . ] discard fan or return to an authorized service facility for examination and/or repair. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fire Protection Association (NFPA), the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities. When cutting or drilling into wall or ceiling; do not damage electrical wiring and other utilities. [. . . ] 4 cm) from wall, not cabinet frame To wire through wall: Mark a line distance "A" from the right of the centerline on the underside of the wall. Use saber or keyhole saw to cut a rectangular opening in the wall for the vent. 1 cm) from the back wall on the centerline of the underside of cabinet. 1 cm) from the back wall on the centerline of the underside of cabinet. Cabinet cutouts *From wall, not cabinet frame *From wall, not cabinet frame Make 2 lines by measuring ³/" (0. 8 cm) down from underside of cabinet and mark on the centerline on the back wall. To make a circular vent opening on the underside of the cabinet top: 1. Use a compass or a circle template to draw a circle with a diameter that is ¼" (0. *From wall, not cabinet frame Install vent through the vent opening in upper cabinet or wall. Depending on your installation, remove either top or rear rectangular vent knockout. 5 cm) on either side of the hood center to accommodate off-center ductwork. If using rectangular vent, attach rectangular damper/vent connectors to the range hood using sheet metal screws. 4 cm) space between screw heads and cabinet to slide range hood into place. Run the home power supply cable according to the National Electric Code or CSA standards and local codes and ordinances. There must be enough wiring from the fused disconnect (or circuit breaker) box to make the connection in the hood electrical terminal box. Then slide the cover toward the outside edge of range hood to position the large end of the keyhole slots over the mounting tabs. NOTE: If the wall cap is directly behind the vent connector, the dampers in the connector and wall cap must not interfere with each other. If using round vent, attach vent transition piece (purchased separately) to range hood top using sheet metal screws. Remove the power supply knockout from the top or rear of the vent hood (depending on the incoming location of your home power supply cable) and install a UL Listed or CSA approved ¹/" strain relief. Connect green (or bare) ground wire from home power supply to yellow-green ground wire (C) in terminal box using UL listed wire connectors. Feed enough electrical wire through the ½" UL listed or CSA approved strain relief to make connections in the terminal box. Position the range hood so that the large end of the keyhole slots are over the mounting screws. [. . . ] The cost of repair or replacement under these excluded circumstances shall be borne by the customer. If outside the 50 United States and Canada, contact your authorized Whirlpool dealer to determine if another warranty applies. If you need service, first see the "Troubleshooting" section of the Use & Care Guide. After checking "Troubleshooting, " you may find additional help by checking the "Assistance or Service" section or by calling Whirlpool. [. . . ]