User manual AT&T 1717

[. . . ] 1 Press and hold C until the Message Window displays C, and the default day is announced. 2 To change the day setting, hold down or until the correct day is announced. 4 To change the hour setting, hold down or until the correct hour is announced. 6 To change the minutes setting, hold down or until the correct minutes setting is announced. [. . . ] The system stops recording and resets to answer calls. Feature Set Up You can set up one feature at a time as described below, or you can set up a feature, and then move on to set up another feature. After you change one feature, press and release S until you hear the voice prompt for the next feature you want to change -- OR -- 3 OPERATION Announcement Monitor You can choose whether to hear the announcement when your system answers a call, or have it silent (off) on your end (your caller will still hear an announcement). After the Ring Select setting is announced, continue to press and release S until the system announces "Monitor is on (or off)". 3 Press and release P or S to exit. Saving Messages The system automatically saves your messages if you do not delete them. The system can save about 12 minutes of messages, including your announcement, for a total of up to 59 messages. When memory is full, you must delete some or all messages before new messages can be recorded. Deleting Messages Delete all messages -- Hold down D. The system announces "Messages deleted" and permanently deletes messages. If you haven't listened to all of the messages, the system beeps five times, and does not delete messages. Delete selected messages -- Press and release D while the message you want to delete is being played. If you want to check a message before you delete it, you can press to replay the message before deleting it. When the system reaches the end of the last message, the messages not deleted are renumbered, and the Message Window displays the total number of messages remaining in memory. Listening to Your Messages As the system plays back messages, the Message Window displays the number of the message playing. Before playing each message, the system announces the day and time the message was received. After playing the last message, the system announces "End of messages. " Play all messages -- Press and release P. If you have no messages, the system announces "No messages. " Play new messages only -- Hold down P for about two seconds, until the system begins playing. If you have no new messages, the system announces "No new messages. " Repeat entire message -- Press and release . Repeat part of message -- Hold down until you hear a beep, then release to resume playing. The more beeps you hear, the farther back in the message you will be when you release the button. Repeat previous message -- Press twice, continue this process to hear other previous messages. Skip part of a message -- Hold down until you hear a beep, then release to resume playing. The more beeps you hear, the farther into the message you will be when you release the button. Stop message playback -- Press and release P. Recording a Memo You can record a memo to be stored as an incoming message. The memo can be up to three minutes long, and will be played back with other messages. [. . . ] In some cases, the system might be affected by the ringing system used by the local telephone company. If the system's memory is full or the system is off, the system answers after 10 rings. Message Window Displays Clock needs to be reset. Flashing ­ System is busy or in use --OR-- Steady ­ System in Remote Access mode. Memory is full --OR-- Announcement monitor is off (shown during Setup). [. . . ]