User manual AT&T 135

[. . . ] The temporary tone dialing is activated by pressing while in pulse mode. Remove the base by sliding it sideways as indicated by the "REMOVE" arrow. Insert the base tabs into the slots on the bottom of the telephone and feed the line cord through the hole in the wide end of the base. [. . . ] The number will remain in memory until you change it by dialing another telephone number. Flash Press instead of pressing the switchhook to activate customer calling services such as call waiting or three-way calling. You may have to press other buttons before or after as explained in custom calling instructions provided by your local telephone company. Ringer Volume The RINGER volume switch allows you to adjust the loudness of the telephone ringer from OFF to HI. Volume Buttons The VOLUME button adjusts the handset during your call. Dial Mode This telephone has a selectable push-button dial and will work with either tone or rotary telephone service. It can be set to work directly with long distance or certain other services that require tone signaling including some tone activated computer systems. (Turn over for more Operation, Memory and In Case of Difficulty) 4 AT&T 135 Quark pdf 7/22/98 11:26 AM Page 6 OPERATION (continued) Temporary Tone Dialing Temporary tone dialing is used only when you have rotary service. It allows you access to services that require tone signaling, including some toneactivated computer systems (e. g. , telephone banking). After you hang up, the phone automatically returns to rotary service. MEMORY Memory Features Numbers will remain stored in memory unless you erase or change them by entering other numbers. Capacity: This telephone can store up to 9 different phone numbers, each up to 24 digits long. Speed Dialing: Nine telephone numbers can be stored in standard speed-dialing locations. This feature is provided only as a convenience and the manufacturer assumes no responsibility for customer reliance upon the memory feature. 5 AT&T 135 Quark pdf 7/22/98 11:26 AM Page 7 MEMORY (continued) Directory Card: Remove the directory card. Also write the telephone numbers (or names) that you want to store in each memory location. Reinstall the card and clear plastic cover. NOTE: Numbers programmed into a memory location might not be retained if the telephone has been unplugged from the line jack for a half hour or more. Speed Dialing To program numbers into memory: 1. [. . . ] If there are several other phones on the same line, try disconnecting some of the other telephones. Having too many telephones can also create problems such as low ringer volume or impaired quality during calls. Other Problems Make sure you have followed all the instructions in this manual. [. . . ]