User manual AMX COLOR ACTIVE VIDEO TOUCH PANEL (G3 FIRMWARE)

[. . . ] instruction manual 6" Color Video Touch Panels (Firmware version G3) Touc h Pa n els an d A cc e ss o r ie s AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: · · · Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, and MX Series products are warranted for a period of one (1) year. AMX Lighting products are guaranteed to switch on and off any load that is properly connected to our lighting products, as long as the AMX Lighting products are under warranty. AMX Corporation does guarantee the control of dimmable loads that are properly connected to our lighting products. [. . . ] Refer to the TPDesign3 Touch Panel Program instruction manual for more information. To download bitmaps, icons and/or fonts from an existing TPDesign3 project file: 1. Launch the TPDesign3 software program and open a project file that contains the desired bitmaps, icons, and fonts. In the File menu, click on Download to Panel, this opens the Download to Panel dialog box. Click on the Comm Settings tab to set the communications port, baud rate, and other settings. Then, click the Actions tab to set the communication mode and select which elements of the project file you want to download to the touch panel. In the What To Send area, select one or more of the available options (All Bitmaps, All Icons, All Fonts). Select the mode of communication with the touch panel (RS-232 and AXlink). Confirm that the correct panel is selected by verifying the ID values with the Base Address assigned to the touch panel in the Protected Setup page. After clicking Connect, the Available Panels list appears in the Available Panels field. After completing the download, the bitmaps, icons and fonts that were downloaded are now accessible via the BITMAPS, ICONS and FONTS menus. Creating a Bargraph and Joystick Bargraphs are level monitors and adjustable level controls. These levels can be configured to monitor and adjust audio outputs and lighting levels. Joysticks are vertical and horizontal direction controllers you can use for camera for pan and tilt control. Before starting, make sure to connect the touch panel to your Controller; otherwise, the joystick will not work properly. 6" Color Video Touch Panels 27 Designing Touch Panel Pages Adding a bargraph or joystick button\ Create a new button using the Add operation bar in the BUTTON menu. Press PROPERTIES in the BUTTON menu to open the PROPERTIES operation bar. Choose a button type to open its Button Properties page. Setting Bargraph and Joystick Properties Use the Button Properties page to set channel, level, and button colors. Refer to the Setting the variable text code section on page 26 and the Setting the channel code section on page 25 for further information. Refer to the Setting the button colors for channel-off conditions section on page 26 for more information on colors for channel-off conditions. Setting the level code Level buttons set the device and number codes for the touch panel. Joysticks use two level numbers. The programming software uses device codes 1 - 4 to identify the touch panel. Press ENTER to save the level device number, close the keypad, and return to the Button Properties page. Press NUM to open a keypad and set the level number assigned to the device. [. . . ] Carefully pry the battery out of its socket and insert the new battery. Connect the touch overlay's ribbon cable connector to the circuit card. Re-insert and tighten the housing screws to their four locations along the outside of the housing. 6" Color Video Touch Panels 57 Replacing the Battery 14. Grip the CV6 unit, from either sides of the enclosure, and while angling the front of the CV6 unit upwards, connect the AXlink and/or BNC connectors. [. . . ]