User manual ALPATEC ISSIMO 9

[. . . ] ⷠAll interventions made by a non-qualified person can be dangerous; in this case guarantee conditions would cancel. ⷠWipe up any water spills immediately after loading or unloading water bottles. ⷠDo not use with water that is microbiologically unsafe or of unknown quality. Children, the disabled and the elderly are at highest risk of being scalded. [. . . ] 5cm) of space between the back of the water dispenser and the wall to allow proper air circulation. ⷠDo not install the water dispenser where the temperature will go below 10°C or above 32°C. ⷠInstall the water dispenser on a level floor or counter strong enough to support it when fully loaded. ⷠDo not install where it will be subject to direct sunlight, heat or moisture. Do not plug in the power cord or turn on the power switches when the waterdispenser is empty. First time to cool / first time to warm 40 - 45 min 9 min Make sure the dispenser is unplugged with both the hot and cold power switched off. ⷠWash hands and wipe the adaptor and the top of the bottle with a clean cloth. ⷠAvoid touching the part of the bottle and adaptor that will be in contact with the water dispenser. ⷠMake sure the water level in the top of the dispenser is low enough to allow for proper bottle installation. Drain the water in the water dispenser until no water flows out from the tap. Unscrew the cold and hot water drain buttons and complete drain the water from the water dispenser. It may cause the water flow about the inside unit and short circuit may occurs. Before turning on the power supply and connect the power switch on the water dispenser, make sure there is a bottle with sufficient water on the water dispenser, and water can flow out from both taps. Periodically the water dispenser tanks must be cleaned to prevent unpleasant tastes in the water and to remove mineral deposits that can impair flow. Before cleaning, set the power switch to off, and unplug the power cord. Do not directly inject bleaching powder into the water dispenser, as concentrated bleaching powder solution may damage plastics. Fit an adaptor onto the bottle and place it on the water dispenser (See Loading the dispenser). Press the hot water key, cold water key and cool water key (depending on respective types), so that water flows out homogeneously from both taps of the water dispenser. [. . . ] Press the hot water key, cold water key and cool water key (depending on respective types), so that water flows out homogeneously from both taps of the water dispenser. Drain water from the water tanks of the water dispenser (see Drain from water dispenser), and put on the water dispenser plug. Add clean water into the water dispenser bottle and drain water from the taps until no more water flows out, and drain water from the water tanks of the water dispenser (see Drain from water dispenser). Drain water from the water tanks of the water dispenser (see Drain from water dispenser), put on the plug, fit the bottom cover and screws with a screwdriver. [. . . ]