User manual AEG-ELECTROLUX SWS98820G0

[. . . ] Repairs and modifications must only be carried out by a qualified service engineer. Disconnect from the mains when cleaning; pull out the plug or deactivate the fuse. Always take hold of the plug itself and pull it straight out of the socket. This appliance is CFC- and HFC-free and contains small quantities of Isobutane (R600a), an environmentally friendly coolant. [. . . ] You will find the climatic classification on the nameplate inside the appliance on the top right-hand side. The following table specifies the ambient temperature range for each climatic classification: Climatic classification SN N ST T for an ambient temperature of +10 to + 32° C +16 to + 32° C +18 to + 38° C +18 to + 43° C An adequate flow of air to and from the cooling system must be ensured. The cooler needs air The cooler door seals the installed unit almost completely, so an air vent must be provided in the base of the housing. Warmed air must be conducted via the ventilation shaft to the rear wall of the housing and then expelled upwards. The ventilation channels should measure at least 200 cm2 in cross-section. To ensure the proper functioning of the appliance, air vents should never be blocked or covered. After installing the unit, and particularly if the door hinge is reversed, please ensure that the door seal is tight all round. An imperfect door seal can lead to increased condensation and thus to higher energy consumption (see the section headed "Troubleshooting"). Electrical connection A properly installed socket outlet with earthing contact is required for electrical connection, positioned so that it is possible to pull out the mains plug. The socket outlet with earthing contact used to connect the appliance should be positioned on the left or right-hand side adjacent to the housing. Electrical fuse protection of at least 10/16 amperes must be provided. If the socket is no longer accessible once the appliance has been built-in, suitable measures must be taken during electrical installation to ensure that the appliance can be disconnected from the mains (fuse, LP [line protection] contact opening width of at least 3 mm). Before operating the appliance, check the data plate to ensure compliance of the connection voltage and type of frequency with the mains network values at the installation site. Select upper zone temperature (5 to 18° C, adjustable) Recommendation: 5­12° C (ideal for white wine, see page 11) Press for at least 3 seconds indicator flashes The temperature can be adjusted in steps. 2a Select lower zone temperature (5 to 18°C, adjustable) Recommendation: 12­18° C (ideal for red wine, see page 11) The temperature set for the lower zone must always be the same as or higher than that in the upper zone. The appliance cools the upper zone for 24 hours at +5° C and then automatically at the set temperature. Interior light switched on permanently: Press for 3 seconds ON Interior light on only while the door is open: Press for 3 seconds OFF If the door is kept open for longer than 5 minutes, an acoustic door alarm will sound. Note: Please use only original LED light fittings provided by the manufacturer. Proper loading The appliance is separated into 2 adjustable temperature zones (both adjustable from 5 to 18° C): Top compartment Bottom compartment white wine, champagne, sparkling wine, rosé wine. Please ensure that the temperature set for the bottom compartment is always at least the same as or higher than that in the top compartment. Ideal drinking temperatures* 6 ­ 8° Champagne, sparkling wines, Chasselas, Riesling, Sauvignon Blanc, young Chardonnays and sweet wines, all rosé wines 8 ­10° Mature Chardonnays and Sauternes 13 ­15° Gamay, young Merlots, young Pinot Noir wines 15 ­17° Young Bordeaux, light Cabernet, Barbera, Merlot 16 ­18° Big Burgundies, Bordeaux, Italian, Spanish and Californians, etc. 17­18° Barolo, Reciotto Amarone (The lower temperature is suitable for more simple wines, and the higher for the more complex, better quality wines of each category). [. . . ] Guarantee conditions Standard Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance: 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation. However, a certain level of noise, dependent on the size of the cooler, is inevitable. Operating noise will be most audible immediately after the compressor cuts in. [. . . ]