User manual AEG-ELECTROLUX ST 500

[. . . ] Advice for your safety Typically the A-weighted sound pressure level of the tool is 82 dB (A). This jig saw can cut wood, plastic and metal; it can cut straight lines, bevels, curves, and internal cut-outs. Connect only to a single-phase AC current supply and only to the mains voltage specified on the rating plate. [. . . ] Loosen the fixing screw, pull the base plate out of the mounting, set it at the required angle (15o, 30o, 45o), push it back into the mounting and tighten the fixing screw again. Angles other than 45o can be set by not pushing the base plate back into the mounting. Moving the base plate Loosen the fixing screw, push the base plate to the rear and tighten the fixing screw again. Moving back For cutting a hole with a short saw blade and sawing near the edge. Take the fixing screw out, push the base plate to the rear and screw the fixing screw tightly into the rear hole. In this position the base plate can also be off-set in longitudinal direction. Push in and turn the suction hose into the Push the transparent cover downwards to The anti-splintering device almost entirely prevents the edge of the wood from splintering. Place the anti-splintering device as shown in the illustration with the smooth side downwards and flush with the base plate (this is only possible with the base plate in the forward position). The stroke rate appropriate to the material being worked on can be taken from the following table, and the corresponding letter shown on the setting wheel. Intermittent use Switching on: Press On-/off switch Switching off: Release On-/off switch Continuous use Switching on: Press the On-/off switch and then the locking button, after that release on-off switch. Adjusting the pendulum stroke (only applicable for STEP 500) ENGLISH 4 By adjusting the pendulum action the cutting depth of the saw blade teeth is increased or decreased. As a rule of thumb: Soft material Hard material Clean cut surface Large pendulum stroke Small or no pendulum stroke No pendulum stroke ST 500, STE 500, STEP 500 The letters A to G are printed on the speed control, meaning: A = lowest stroke rate G = highest stroke rate The stroke-rate (= movements per minute of the saw blade) can be infinitely varied by means of the adjustment wheel. The appropriate degree of pendulum effect can be taken from the following chart and compared with the marking at the pendulum stroke lever. The stroke rate can be set on the stroke rate control even while the motor is running. [. . . ] Ensure that the saw blade and the circle centre point form one single line. When working on delicate surfaces please use the plastic protection shoe. Fit the plastic protection shoe to the front of the base plate (as illustrated) and fix the lugs with the back of the base plate. [. . . ]