User manual AEG-ELECTROLUX SKD71800F0

[. . . ] · Do not use a mechanical device or any artificial means to speed up the thawing process. · Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances, unless they are approved for this purpose by the manufacturer. · The refrigerant isobutane (R600a) is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable. During transportation and installation of the appliance, be certain that none of the components of the refrigerant circuit become damaged. [. . . ] To achieve sufficient ventilation follow the instructions relevant to installation. · Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. · The appliance must not be located close to radiators or cookers. · Make sure that the mains plug is accessible after the installation of the appliance. · Connect to potable water supply only. 3) Service · Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. · This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. OPERATION Switching on Insert the plug into the wall socket. Turn the Temperature regulator clockwise to a medium setting. Switching off To turn off the appliance, turn the Temperature regulator to the "O" position. Temperature regulation The temperature is automatically regulated. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. Periods of non-operation When the appliance is not in use for long periods, take the following precautions: · disconnect the appliance from electricity supply · remove all food · defrost 4)and clean the appliance and all accessories · leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. WHAT TO DO IF. . . WARNING!Before troubleshooting, disconnect the mains plug from the mains socket. Only a qualified electrician or competent person must do the troubleshooting that is not in this manual. 4) If foreseen. 10 What to do if. . . There are some sounds during normal use (compressor, refrigerant circulation). Problem Possible cause Solution Switch on the appliance. The appliance does not op- The appliance is switched off. The lamp does not operate. The mains plug is not connecConnect the mains plug to the ted to the mains socket correct- mains socket correctly. Connect a different electrical apThere is no voltage in the mains pliance to the mains socket. During the automatic defrosting process, frost defrosts on the rear plate. Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate class SN N ST T +10°C to + 32°C +16°C to + 32°C +16°C to + 38°C +16°C to + 43°C Ambient temperature Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The power supply cable plug is provided with a contact for this purpose. [. . . ] Attach the hinge covers (E) to the hinge. D C E E 7. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). 16 Installation 8. Install the part (Ha) on the inner side of the kitchen furniture door. ca. 50 mm 21 mm 9. Push the part (Hc) on the part (Ha). Ha Hc 10. Open the appliance door and the kitchen furniture door at an angle of 90°. [. . . ]