User manual AEG-ELECTROLUX SC71440-6I

[. . . ] With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. [. . . ] Fasten the appliance with 4 screws provided in the kit included with the appliance. From the plastic cover (E), which is used to cover the hinge with the pivot pin, you must take away the part as indicated in the drawing. This operation is made easer since there is, in the internal part of the cover hinge lid a groove that facilates the removal of this coomponent. Separate parts Ha, Hb, Hc, Hd as shown in the figure Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). Place the small square on the guide again and fix it with the screws supplied. Should the lining up of the furniture door be necessary, use the clearance of slots. Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. However, the exact setting should be chosen keeping in the mind that the temperature inside the refrigerator depends on: -the quantity of food stored -how often the door is opened The temperatures in the refrigerator compartment and freezer co partment cannot be independently regulated. If you want the freeze fresh food rapidly, select setting , , 6", ensuring that the temperature in the refrigerator compartment does not drop blow 0°C. On hot summer days) and a cold setting on the temperature regulator (position"5" to "6") can cause the compressor to run continuously. If this happens, turn the temperature regulator back to a warmer setting (position "3" to "4"). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced. When the room temperature is + 16° C or less push the the Low Room Temperature Switch A. Please note that in this setting the interior light will remain on, even if the door is closed. The glass shelf above the fruit and vegetable compartment should always remain in position, to ensure fruit and vegetables stay fresh longer. The remaining storage shelves can be adjusted to various heights: Pull the storage shelf forward until it can be tipped up or down and remoD338 ved. Adjustment for tall goods: Remove the front half of the two-part vario glass storage shelf and insert it at a different level. [. . . ] Remove the mains plug or switch off or turn out the circuit breaker or fuse. defrost freezer compartment and clean thoroughly (see section: "Cleaning and Care"). For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. Before cleaning switch the appliance offand rem ve the plug from the mains, or switch off or turn out the circuit breaker or fuse. [. . . ]