User manual AEG-ELECTROLUX SB01ECEN

[. . . ] Be certain you are pushing the igniter to light the burners you intend on using. WARNING If you smell gas: 1. If odor continues, immediately call your gas supplier. TESTED IN ACCORDANCE WITH ANSI Z21. 58a-1998/CGA 1/6a-M98 STANDARD FOR OUTDOOR COOKING GAS APPLIANCES. Check your local building codes for the proper method of installation. In the absence of local codes, this unit should be installed in accordance with the National Fuel Gas Code No. [. . . ] Under the grill, remove the NG gas regulator assembly from the main gas pipe. Once the NG gas regulator is removed, the main gas pipe will be showing under grill. Using pipe sealant, attach the "T" Fitting to the main gas pipe coming out of the bottom of the grill. Using pipe sealant, attach a 3/8" flared fitting to the side of the "T" fitting. Attach the one end of the flex line to the fitting on the side of the "T" fitting. (See Fig 4) Note: This line can be extended using a 3/8" flared coupling and an additional flex line if necessary. Using pipe sealant, attach a 3/8" nipple to the bottom of the "T" fitting. Using pipe sealant, attach the NG gas regulator to the 3/8" nipple. (See Fig 7) Note: Make sure all fittings are tightened with a wrench. Fig. 6 Fig. Loosen the flex line attached to the side burner valve using an adjustable wrench. Remove the screw holding the bezel in place on the side burner and remove bezel from front of side burner. Grasp and remove NG valve assembly from the side burner tube assembly and remove from the side burner. 5) Flex Line Underside of right side burner shelf Fig 1 Flex Line Valve Assembly Fig 2 6. 6) Fig 3 Screw Bezel Fig 4 Fig 6 Fig 5 LP valve Assembly LP Side Burner Conversion 7. Looking down at top of side burner, use a 7mm nut driver to remove the NG. From the bottom of the side burner place the LP orifice into the main burner assembly, finger tighten. Using the 7mm nut driver tighten the LP orifice in the main burner assembly. This completes the side burner conversion. NG orifice Fig 7 Flex line attached Top of Side Burner Looking down Fig 8 LP orifice Fig 9 Bottom of side burner main assembly Fig 10 LP orifice Nut driver through top of side burner Fig 11 LP Grill Conversion IMPORTANT: Make sure you have converted the side burner to Liquid Propane prior to completing the following steps. Using an adjustable wrench remove the flare fitting coming out of the bottom of the grill. Once the flare fitting is removed the main gas pipe will be showing under grill. Using pipe sealant, attach the "T" Fitting to the main gas pipe coming out of the bottom of the grill and tighten with a wrench. [. . . ] This limited warranty does not cover any scratches, dents, corrosion or discoloring by heat, abrasive and chemical cleaners nor any components used in the installation of the appliance. Keep your bill of sale, delivery slip, or some other appropriate payment record. The date on the bill establishes the warranty period should service be required. If service is performed, it is in your best interest to obtain and keep all receipts. [. . . ]