User manual AEG-ELECTROLUX SANTO K 9 18 00-5I

[. . . ] The refrigerant isobutane (R600a) is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable. ⷠDuring transportation and installation of the appliance, be certain that none of the components of the refrigerant circuit become damaged. ⷠIf the refrigerant circuit should become damaged: ­ avoid open flames and sources of ignition; ­ thoroughly ventilate the room in which the appliance is situated. Safety of children Wraps, polystyrene) can be dangerous for children. [. . . ] If these clearances cannot be maintained a heat insulating pad is required between the cooker and the refrigeration appliance. Your appliance needs air For safety reasons, minimum ventilation must be as shown Fig. Attention: keep ventilation openings clear of obstruction; The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. When changing the side at which the door opens, the appliance may not be connected to the mains. Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. The temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the display of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, "C" (+) or "E" (-). Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. If neither button is pressed, the temperature display automatically switches back after a short period (approx. During normal operation, the temperature currently present in the fridge (ACTUAL temperature) is displayed. When the temperature is being adjusted a flashing display indicates the fridge temperature currently set (DESIRED temperature). each time the button is pressed the temperature is adjusted by 1 °C. From a food safety point of view +5 °C should be considered sufficiently cold for storing food in the fridge. Once the required temperature has been set, after a short period (approx. ) the temperature display will change and again indicate the current ACTUAL temperature inside the fridge. When the setting is changed, the compressor does not start immediately if automatic defrosting is currently taking place. As the storage temperature within the fridge is reached quickly you can store food immediately after switching on. The COOLMATIC function is suited for quick cooling of large quantities of goods in the refrigerator. [. . . ] A large quantity of warm food was placed in the appliance within the last 24 hours. Carefully warm the leaking sections of the door seal with Door seal is not air tight (pos- a hair dryer (not hotter than Heavy build up of frost, possisibly after changing over the approx. A pipe, on If necessary, carefully bend the rear of the appliance is the component out of the touching another part of the way. The compressor does not start This is normal, no error has immediately after changing occurred. [. . . ]