User manual AEG-ELECTROLUX S75348KG9

[. . . ] S 75348 KG9 S 75348 KG98 Refrigerator freezer combination Instruction book A/AE/NY13-2. (08. ) 200372738 PERFEKT IN FORM UND FUNKTION Dear customer, Before switching on your new appliance please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. These operating instructions are for use with several technically comparable models with varying accessories. [. . . ] The temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the display of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, (I) or (K). Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. If neither button is pressed, the temperature display automatically switches back after a short period (approx. DESIRED temperature means: The temperature that has been selected for inside the freezer. ACTUAL temperature means: The temperature display indicates the current temperature inside the freezer. The ACTUAL temperature is indicated with illuminated numbers. Temperature display The temperature display can indicate several pieces of information. During normal operation, the temperature currently present in the freezer (ACTUAL temperature) is displayed. When the temperature is being adjusted a flashing display indicates the freezer temperature currently set (DESIRED temperature). 16 Starting Up - Setting the Temperature 1. The temperature display switches over and the DESIRED temperature currently set flashes on the temperature display. Set the required temperature by pressing the (I) or (K) buttons (see section "Temperature setting buttons"). Each time the button is pressed the temperature is adjusted by 1 °C. From a food safety point of view -18 °C should be considered sufficiently cold for storing food in the freezer. FROSTMATIC The FROSTMATIC function accelerates the freezing of fresh food and, at the same time, protects foodstuffs already stored from undesirable warming. The FROSTMATIC function is switched on by pressing the FROSTMATIC button (H). If the FROSTMATIC function is not ended manually, the appliance will switch off the FROSTMATIC function after about 52 hours. The FROSTMATIC function can be ended manually at any time by pressing the FROSTMATIC button again. The yellow light goes out. Alarm reset button In the event of an abnormal temperature rise inside the freezer (e. g. power cut) warning light (M) will start to flash and a buzzer will sound. Push the alarm reset button (L) to stop the buzzer sound, while the warning light will continue to flash. The buzzer will stop automatically when the temperature has returned to normal while the warning light (M) will continue to flash. If we press the alarm reset button (L) we stop the warning light and at the same time the indicator show for about 5 seconds the warmest temperature reached in the compartment. 17 Switching the Appliance off To switch off, hold down the (A) button. Remove the mains plug or switch off or turn out the circuit breaker or fuse. Defrost the freezer compartment and clean the appliance thoroughly (see section: "Cleaning and Maintenance"). [. . . ] Place the products in a way so that cold air could circulate among them. 24 Problem Possible cause Solution The compressor oper- The thermostatic control is set wrong- Set the thermostat knob to a position ates continually. Start the appliance according to instructions in chapter 'Putting it into use'. Electrical network broke down. The appliance is not supported proper- Check if the appliance stands stable ly. (all the four feet should be on the floor). Inasmuch as the advice does not lead to result, call the nearest brand-mark service. 25 How to change the bulb Should the light fail to work you can change it as below: Break the circuit of the appliance. [. . . ]