User manual AEG-ELECTROLUX LUX T20-1141SA

[. . . ] INSTALLATION AND OPERATING INSTRUCTIONS 52021 INSTALLATION & OPERATION 1). THERMOSTAT LOCATION For accurate temperature control and comfort, correct location is very important. [. . . ] Bring wires through large hole in decorative wall plate and through Hole For Wires in Base. Place a level against the bottom of the Base, adjust until it is level and then tighten mounting screws to secure the Base. SPECIFICATIONS ELECTRICAL RATING 24 Vac (30 Vac Maximum) SWITCH ACTION Open Contact Switch ANTICIPATOR RATING 0. 15A to 1. 2A TEMPERATURE RANGE 50°F to 90°F LUX PRODUCTS CORPORATION Mt. Laurel, New Jersey, 08054 USA © COPYRIGHT 2006 LUX PRODUCTS CORPORATION. ALL RIGHTS RESERVED Attach wires to terminal screws shown in Figure 2. (Either wire to either terminal) Push excess wire back into wall opening. Do this by carefully sliding the long pointer on the anticipator over the desired number. If old anticipator setting cannot be determined, look on gas control on furnace, or set it at . 6. During heating season, furnace should operate about five times an hour. If adjustments are necessary, move heat anticipator pointer slightly and recheck. Turn electricity and gas back on and set pointer on top of thermostat to desired temperature. FIGURE 3 DECORATIVE WALL PLATE A thermostat can only control temperature near it. If you find that it is uncomfortable some distance away from the thermostat, change the setting in order to compensate for this. FIGURE 1 FRONT COVER TECHNICAL ASSISTANCE If you have any problems installing or using this thermostat, please carefully and thoroughly review the instruction manual. If you require assistance, please contact our Technical Assistance Department at 856-234-8803 during regular business hours between 8:00AM and 4:30PM Eastern Standard Time, Monday through Friday. [. . . ] However, this product may replace a unit which contains mercury and should not be disposed of in the trash. Contact your local waste management authority for proper disposal instructions for mercury in a sealed glass tube. [. . . ]