User manual AEG-ELECTROLUX LUX LV1-2

[. . . ] Laurel, New Jersey 08054, USA 43371 G W WARNING: Use Energizer® or DURACELL® Alkaline Batteries Only. Energizer® is a registered trademark of Eveready Battery Company, Inc. DURACELL® is a registered trademark of The Gillette Company, Inc. Please read all instructions carefully before beginning installation. Before removing any wiring from your existing thermostat, its wires must be labeled with their terminal designations. Ignore the color of the wires since they may not comply with any standard. Thank you for your confidence in our product. [. . . ] A smaller swing number increases the number of cycles, so room temperature is more constant. A larger swing number decreases the number of cycles, but saves energy in most cases. 2 WIRE SYSTEM HEAT ONLY PROGRAMMING B JUMPER G Y W RH RC O The CAG1500 provides four independent programming periods per day for HEAT, COOL, and FAN. You can use the default programs or alter them to suit your schedule. DEFAULT ENERGY STAR® TEMPERATURE PROGRAM As supplied from the factory, the following ENERGY STAR® approved program will be used for temperature control in RUN mode. This program and all other software settings may be restored to their default values via a SOFTWARE RESET. SWING SETTING 1. Rotate the dial to the RUN position to finish. EASY PROGRAMMING WITH LUX SPEED DIAL® HEAT 24 VOLT HEAT TRANSFORMER 120 V CA 3 WIRE SYSTEM HEAT ONLY (3rd WIRE FOR FAN) G G G G G G G G G G G Small elegant design Exclusive LUX Speed Dial® EL Illuminated Display Comprehensive Graphical Filter Monitor 7 Day Programming Energy Star Compliant 4 Periods Per Day Independent Fan Program Programmable (minimum) Fan Duty Cycle Nonvolatile Memory For All Programs And Settings Temporary Temperature Override G G G G G G G Temperature Hold Keyboard Lockout F/C Temperature Display 12/24 Hr Clock Display Adjustable Temperature Differential / Cycle Rate User Temperature Offset / Calibration 5/2 minute selectable minimum Run/Off time provides short cycle and compressor protection G Y W RH RC B JUMPER O PERIOD HEAT MODE COOL MODE Morning 6:00 AM 70°F (21°C) 6:00 AM 78°F (26°C) 8:00 AM 62°F (17°C) 8:00 AM 85°F (29°C) Day Evening 6:00 PM 70°F (21°C) 6:00 PM 78°F (26°C) 10:00 PM 62°F (17°C) 10:00 PM 82°F (28°C) Night TEMPERATURE CALIBRATION 1. Use UP/DOWN keys to adjust the thermostats calibration by as much as ± 5°F (± 3°C). EDITING HEAT OR COOL PROGRAMS You can change any preset times and/or temperatures to suit your schedule for each day of the week. The four periods each day are Morning(MORN), Day, (DAY) Evening(EVE), and Night(NITE). LOCK To prevent tampering, press NEXT NEXT NEXT HOLD. This sequence of keys will lock and unlock the set temperature, programs and other settings. When the keys are locked, a padlock icon will be visible above the time and temperature display. The Lock will be disabled after a Hardware Reset. MO NITE FAN HEAT 24 VOLT HEAT TRANSFORMER 120 VAC WEEKDAY PROGRAMMING 1. You will see the display shown here: PROGRAM MO MORN START AT AM 1:30 70 120 HEAT SET FILTER 3 WIRE SYSTEM COOL ONLY G Y W RH RC B JUMPER O 6:00 70 HEAT SET SETUP OPTIONS JUMPER SETTINGS There are four jumpers, each controls a setting depending on its position. CAUTION The CAG1500 is protected against normal static electric discharges. Install two new Energizer or DURACELL "AA" size alkaline batteries in the battery compartment. Hang the top of the unit by the tabs at the top corners of the base, then snap the bottom of the unit into place. If the body does not snap into place easily, remove the body, re-hang it from the tabs and try again. Turn the power back on to your heating and/or air conditioning system. If this is the first time you are installing batteries, the thermostat will display "SUN 12:00 AM". Within 90 seconds the thermostat will begin to display the room temperature alternately with the time. To correct the display, see "Setting the TIME and DAY, " after you set the programs. G Y W ADD JUMPER RH RC B* JUMPER O* MON DAY EVE NIGHT MORN DAY EVE NIGHT MORN FRI TUES SAT FAN HEAT PUMP 24 VOLT HEAT TRANSFORMER 120 VAC CHANGEOVER HEAT CHANGEOVER COOL WED DAY EVE NIGHT SUN CAUTION Read instructions carefully before removing any wiring from existing thermostat. G When removing wires from their terminals, ignore the color of the wires since they may not comply with any standard. G *"B" OR "O" BUT NEVER BOTH CLEAN AIR CYCLE. Install two new Energizer or DURACELL "AA" size alkaline batteries at this time. To do this hang the top of the unit by the NOTE tabs on the base, then snap the bottom Remove sticker from display. If the body does not snap into place easily, remove the body, re-hang it from the tabs and try again. [. . . ] You will see a display FAN MORN similar to that shown here: START AT 2. The start time for the displayed period will flash to show that this may AM be changed. The beginning of that period may not be any closer to the beginning of the next period than one 15 minute increment. When all the periods for a day have been set, the start time for the next morning will be flashing so that it may be edited. [. . . ]