User manual AEG-ELECTROLUX HK 75 A

[. . . ] For safety reasons this power tool is fitted with a switch lock and the On-/Off switch cannot be locked in the"On" position. If a correction of the 90° angle of the guide-plate to the saw blade is necessary, use the correction screw. [. . . ] Sawdust and splinters must not be removed while the machine is running. Before use check machine, cable, and plug for any damages or material fatigue. Dust that arises when working in wood or using the tool on industrial material can be dangerous to health. Protective swing guard operation only with the provided lever or automatically by the workpiece. Do not use saw blades not corresponding to the key data given in these instructions for use. The riving knife should be adjusted so that: the distance between it and the tips of the saw blade teeth does not exceed 5 mm, it is not more than 5 mm away from the lowest point of the tips of the saw blade teeth Do not use cracked or distorted saw blades or HSS saw blades (high speed steel). The teeth thickness, or the set of the teeth must be thicker than the body of the blade and the riving knife. Do not brake the speed of the saw-blade after switching off the motor by pressing on it from the side. Clamp wooden rods on both sides of the saw blade to prevent them from rotating. Do not fix the on/off switch in the "on" position when using the saw hand-held. This electronic circular saw can cut lengthways and mitre accurately in wood, plastic, and aluminium. We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. [. . . ] As well as the machine type printed on the label and order the drawing at your local service agents or directly at: AEG Elektrowerkzeuge, Always disconnect the plug from the socket before carrying out any work on the machine. Manager Product Development NÄTANSLUTNING Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]